درباره ما
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
ASTM D5641/D5641M-25
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 5.1 This practice is a nondestructive evaluation intended to be used for quality control purposes during factory or field seaming of geomembranes. 5.2 This practice may also be used to evaluate geomembrane panels for holes that penetrate the entire thickness of material. Limitations on the test practice are that it may not be suitable for uneven or curved surfaces, thick seams, seams in corners, and thin extensible geomembranes.
Collections
:
-
Statistics
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:26:29Z | |
| date available | 2025-09-30T19:26:29Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | d5641_d5641m-25.pdf | |
| identifier uri | http://yse.yabesh.ir/std;jsessionid=19EDF98DDCEABA1787A29D9D7C83761E/handle/yse/343577 | |
| description abstract | 5.1 This practice is a nondestructive evaluation intended to be used for quality control purposes during factory or field seaming of geomembranes. 5.2 This practice may also be used to evaluate geomembrane panels for holes that penetrate the entire thickness of material. Limitations on the test practice are that it may not be suitable for uneven or curved surfaces, thick seams, seams in corners, and thin extensible geomembranes. | |
| language | English | |
| title | Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber | en |
| title | ASTM D5641/D5641M-25 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This practice covers procedures to perform nondestructive quality control testing described in Practice D4437/D4437M for evaluating the continuity of all types of geomembrane seams using the bubble emission or vacuum chamber method. 1.2 The technique described in this practice is intended for use on geomembrane seams, patches, and defects. 1.3 This practice can only be used when the seam to be tested is at the edge or covering the edge of the welded material, enabling a vacuum to be created. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D5641_D5641M-25 |