درباره ما
SAE - SAE International: Recent submissions
Now showing items 721-740 of 16264
-
Fitting End, Standard Dimensions for Flareless Tube Connection and Gasket Seal
Abstract: Scope is unavailable. -
Insert - Screw Thread, Thin Wall, Self-Locking, UNS N07718, Silver Plated, Class: 185 ksi/1025 °F, Procurement Specification
Abstract: This SAE Aerospace Standard (AS) establishes the requirements for AS3504 and AS3505 thin wall self-locking inserts made from a corrosion and heat resistant, age hardenable nickel base alloy of the type identified under the ... -
Landing Gear Common Repair
Abstract: This document outlines the most common repairs used on landing gear components. It is not the intention of this AIR to replace overhaul/component maintenance or technical order manuals, but it can serve as a guide into ... -
Bolt, Tee Head - Chamfered, Pd Shank Nickel Alloy (UNS N07001), 165 ksi Min UTS, .3125-24 UNJF-3A
Abstract: Scope is unavailable. -
Circuit Breaker - Aircraft, Trip-Free, Push-Pull, 1/2 Thru 25 Amps, Type 1, -55 Thru +121 °C
Abstract: Scope is unavailable. -
Bolt, Tee Head – Chamfered, AMS5708 (UNS N07001), 165 ksi Min UTS, .1900-32UNJF-3A
Abstract: Scope is unavailable. -
Thermodynamics of Incompressible and Compressible Fluid Flow
Abstract: The fluid flow treated in this section is isothermal, subsonic, and incompressible. The effects of heat addition, work on the fluid, variation in sonic velocity, and changes in elevation are neglected. An incompressible ... -
Tire Quasi-Static Envelopment of Triangular/Step Cleats Test
Abstract: This SAE Recommended Practice describes a test method for determining properties of a non-rolling tire quasi-statically enveloping either a set of triangular cleats or a single step cleat. In the case of the triangular ... -
High Tension Ignition Cable Assemblies - Marine
Abstract: This Standard covers the requirements for all marine inboard and outboard gasoline engine ignition assemblies and components. -
Nomenclature - Hydraulic Backhoes
Abstract: This SAE standard includes hydraulic backhoes which have no more than 190 degrees of rotational swing and are mounted on wheeled tractors and crawler tractors. Illustrations used are not intended to include all existing ... -
Ignition Cable Assemblies
Abstract: This SAE Standard specifies the general requirements and test methods for non-shielded, high-voltage ignition cable assemblies. -
Electromagnetic Susceptibility Procedures for Common Mode Injection (1 - 400 MHz), Module Testing
Abstract: This document establishes a method of determining the relative level of susceptibility of electronicmodules and the improvement or degradation which results from design changes to those modules. Furtherwork needs to be ... -
Welded and Cold-Drawn, High Strength (690 MPa Tensile Strength) Low Alloy Steel Hydraulic Tubing, Stress Relieved Annealed for Bending, Flaring, Cold Forming and Brazing
Abstract: This specification covers stress relieved annealed electric resistance welded and cold-drawn single-wall high strength low alloy steel tubing intended for use in hydraulic pressure lines and in other applications requiring ... -
Commercial Truck and Bus SAE Recommended Procedure for Vehicle Performance Prediction and Charting
Abstract: This SAE Recommended Practice takes into account modern standardized methods for collecting and summarizing data that has an effect on vehicle steady-state performance, such as engine output (gross and net), transmission ...