درباره ما
ISO - International Organization for Standardization: Recent submissions
Now showing items 601-620 of 21282
-
ISO TR 14880-5
Abstract: This part of ISO 14880 gives guidelines for the testing of microlenses. It applies to microlenses in arrays where very small lenses are formed inside or on one or more surfaces of a common substrate.
This part of ISO ... -
ISO ISO/IEC DIS 29145-2
Abstract: This part of ISO/IEC 29145 specifies the MAC of the WiBEEM (Wireless Beacon-enabled 210 Energy Efficient Mesh network) protocol for wireless home network services that supports a 211 low power-consuming wireless mesh network ... -
ISO 12614-7
Abstract: This part of ISO 12614 specifies tests and requirements for the pressure relief valve (PRV), a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This part of ... -
ISO 24978
Abstract: This International Standard deals with intelligent transport systems.
This International Standard provides a standardized set of protocols, parameters, and a method of management of an updateable "Data Registry" to ... -
ISO DIS 14886
Abstract: This standard covers structural fire protection of large FRP commercial yachts of 24 m in length and over, below 500 GT and carrying up to 12 passengers.
It addresses all of the relevant mechanical, thermal and physical ... -
ISO ISO/IEC/IEEE 31320-1
Abstract: The body of the standard describes the modeling language (syntax and semantics) that supports the IDEF0 method for developing graphical representations of a system or subject area. The clauses that follow govern the physical ... -
ISO 11130
Abstract: This International Standard specifies a method for assessing the corrosion resistance of metals by an alternate immersion test in salt solution, with or without applied stress.
The test is particularly suitable for ... -
ISO 20785-1
Abstract: This part of ISO 20785 gives the conceptual basis for the determination of ambient dose equivalent for the evaluation of exposure to cosmic radiation in civilian aircraft and for the calibration of instruments used for ... -
ISO 6363-6
Abstract: This part of ISO 6363 specifies the tolerances on form and dimensions of wrought aluminium and aluminium alloy drawn round tubes (seamless and porthole).
This part of ISO 6363 applies to cold-drawn round tubes. -
ISO 8573-6
Abstract: This part of ISO 8573 provides a selection of suitable test methods from those available for the measurement of contamination gases in compressed air. It specifies sampling technique, measurement and evaluation, uncertainty ... -
ISO ISO/IEC 14476-4
Abstract: This Recommendation | International Standard provides a specification of QoS management for accomplishing desirable QoS for a duplex multicast transport connection. For this purpose, this Specification describes the QoS ...