درباره ما
IEEE - The Institute of Electrical and Electronics Engineers, Inc.: Recent submissions
Now showing items 461-480 of 2683
-
IEEE/ISO/IEC Telecommunications and exchange between information technology systems -- Requirements for local and metropolitan area networks -- Part 3: Standard for Ethernet AMENDMENT 4: Physical layers and management parameters for 50 Gb/s,200 Gb/s, and
Abstract: This amendment to IEEE Std 802.3-2018 adds Physical Layer (PHY) specifications and management parameters for 50 Gb/s, 200 Gb/s, and 400 Gb/s operation over single-mode fiber with reaches of at least 40 km.Subject(s) : amendment , PMD sublayer , single-mode fiber , physical medium dependent sublayer , 400GBASE-ER8 , forward error correction , SMF , 200GBASE-ER4 , 50 Gb/s Ethernet , 50GBASE-ER , FEC , Ethernet , Energy-Efficient Ethernet , IEEE 802.3cn™ , 400 Gb/s Ethernet , 200 Gb/s Ethernet , EEE , PAM4 , IEEE 802.3™ , -
IEEE/ISO/IEC Telecommunications and exchange between information technology systems -- Requirements for local and metropolitan area networks -- Part 3:Standard for Ethernet AMENDMENT 8: Physical layer specifications and management parameters for 2.5 Gb/s,
Abstract: This amendment to IEEE Std 802.3-2018 adds physical layer specifications and 2.5 Gb/s, 5 Gb/s, and 10 Gb/s operation on a single balanced pair of ductors suitable for automotive applications.Subject(s) : Physical Medium Attachment , 5GBASE-T1 , 10GBASE-T1 , MASTER-SLAVE , Medium layer , Physical Layer , Ethernet , IEEE 802.3ch™ , 2.5GBASE-T1 , -
IEEE Guide for Switchgear--Unit Substation--Requirements - Redline
Abstract: The basis for the coordination of equipment in unit substations by assisting in the selection of components is intended as the use of this guide. A variety of designs for unit substations are possible using various ...Subject(s) : control , unit substation , fuse , rectifier-type substation , surge protection , spot-network substation , molded-case circuit breaker , switchgear , power circuit breaker , secondary selective substation , secondary unit substation , metal-enclosed switchgear , metal-clad switchgear , radial substation , transformer , motor control center , mobile unit substation , IEEE C37.121 , gas-insulated switchgear , distribution , substation , metering , primary unit substation , transition section , -
IEEE/ISO/IEC International Standard - Software and systems engineering--Software testing--Part 4: Test techniques
Abstract: The purpose of this part of ISO/IEC/IEEE 29119 is to provide an International Standard that defines software test design techniques (also known as test case design techniques or test methods) that can be used within the ...Subject(s) : test methods , test techniques , defines software test design techniques , systems engineering--software testing--part , software testing industry , test case design techniques , -
IEEE/ISO/IEC International Standard for Software and systems engineering--Software testing--Part 3:Test documentation
Abstract: The purpose of the ISO/IEC/IEEE 29119 series of software testing standards is to define an internationally-agreed set of standards for software testing that can be used by any organization when performing any form of ...Subject(s) : Test Plan , verification and validation. , 29119 , Test Planning Process , 29119-1 , software testing , -
IEEE Standard for Spaceborne Global Navigation Satellite System-Reflectometry (GNSS-R) Data and Metadata Content
Abstract: In February 2019 a Project Authorization Request was approved by the Institute of Electrical and Electronics Engineers (IEEE) Standards Association with the title “Standard for Global Navigation Satellite System Reflectometry ...Subject(s) : Earth observation , GNSS-Reflectometry , IEEE 4003 , -
IEEE Guide for the Rehabilitation of Hydroelectric Power Plants
Abstract: This guide is intended for the hydroelectric power industry to assist hydroelectric power plant owners, operators, and designers in the economic (feasibility) and technical evaluation (electrical aspects) of existing ...Subject(s) : control , fire protection , cable and raceway , turbine , generator , lubrication , machine shop , ventilating and air conditioning , governor , crane , hydroelectric , lighting , transformer , protection , plant security , compressed air , UPS , rehabilitation , water , grounding heating , drainage , telephone , arc-flash , IEEE 1147™ , excitation , -
IEEE Standard for Technical Framework and Requirements of Trusted Execution Environment based Shared Machine Learning
Abstract: The framework and architecture for machine learning in which a model is trained using encrypted data that has been aggregated from multiple sources and is processed by a trusted third party are defined in this standard. ...Subject(s) : TEE , trusted execution environment , shared machine learning , data fusion , IEEE 2830 , SML , -
ISO/IEC/IEEE International Standard - Software and systems engineering - Software testing -- Part 2: Test processes
Subject(s) : ISO international standard , software development lifecycle models , IEEE international standard , IEC international standard , systems engineering , software testing , -
IEEE Guide for the Application of Electric Machines in Zone 2 and Class I, Division 2 Hazardous (Classified) Locations
Abstract: Three-phase and single-phase ac synchronous and induction electric machines in ratings 0.18 kW (1/4 hp) and larger are covered in this guide. Primary emphasis is on the use of open or nonexplosionproof or nonflameproof ...Subject(s) : adjustable speed drive; autoignition temperature; Class I , Division 2; classified locations; electric machine; enclosure sparking; generator; hazardous locations; IEEE 1349; induction motor; label test; motor; motor enclosure; motor temperature; multisection motor; paint test; rotor; rotor sparking; rotor temperature; space heater test; synchronous motor; T Code; temperature code , Zone 2 , -
IEEE/IEC International Standard for High-voltage switchgear and controlgear--Part 37-013: Alternating current generator circuit-breakers
Subject(s) : IEC Standards , Voltage control , Dielectric liquids , Switchgear , Encoding , IEEE Standards , Generators , Control systems , High-voltage techniques , -
IEEE Standard for Adoption of MIPI Alliance Specification for A-PHY Interface (A-PHY) Version 1.0
Abstract: This standard adopts MIPI Alliance--MIPI A-PHY Specification Version 1.0 as an IEEE Standard. The adopted standard provides an asymmetric data link in a point-to-point or daisy-chain topology, with high-speed unidirectional ...Subject(s) : sensor , car noise , Shielded Parallel Pair (SPP) , jitter , IEEE 2977 , asymmetric , coaxial cable , serializer-deserializer , DSI , inline connectors , Packet Duplication , Serial interface , Routing Table , Clock Forwarding Service , PAM-X PCS , descrambler , Local Functions , ISO 26262 , power over coax , NRZ , Packet Forwarding , PAM , Display , PAL/GPIO , PAL/DSI-2 , camera , A-Payload , MIPI Alliance , Multi-Port , Power over Differential Line , Profile , Phy , DSE , AHeader , I3C , PMD , APPI , ACMD , CSE , Physical layer , Eye Diagram , A-PHY , PAM16 , protocol adaptation layer , ACMP , test modes , 8B/10B PCS , low-speed bi-directional command and control data , power distribution , long reach , optimal wiring cost and weight , PAL/I2C , adoption , functional safety , Duplication Table , Lidar , high-speed uni-directional data stream , autonomous driving systems , CSI , Control and Management System Architecture , A-Packet , I2C , gear , PAL/CSI-2 , PAL/eDP-DP , Radar , automotive , Shielded Twisted Pair (STP) , CSI-2 , scrambler , advanced driver assistance systems , infotainment , APDLL , SerDes , DSI-2 , Shielded Differential Pair (SDP) , -
IEEE Guide for Synchronization, Calibration, Testing, and Installation of Phasor Measurement Units (PMUs) for Power System Protection and Control
Abstract: Guidance for synchronization, calibration, testing, and installation of phasor measurement units (PMUs) applied in power systems is provided. The following are addressed in this guide: (a) considerations for the installation ...Subject(s) : PMU , phasor measurement unit , testing , GNSS , synchrophasor , calibration , IEEE C37.242 , -
IEEE Standard for Ratings and Requirements for AC High-Voltage Circuit Breakers with Rated Maximum Voltage Above 1000 V - Corrigendum 1
Abstract: This standard covers the rating structure for all high-voltage circuit breakers, which include all voltage ratings above 1000 V ac and comprise both indoor and outdoor types. Preferred ratings are also provided. Typical ...Subject(s) : interrupting time , power frequency , short-circuit current , indoor , short-line fault , mechanical endurance , insulation capability , outdoor , operating duty , capacitive current switching , related capabilities , ratings , transient recovery voltage , IEEE C37.04 , -
IEEE Standard for Information Technology--Telecommunications and Information Exchange between Systems--Local and Metropolitan Area Networks-Specific Requirements--Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications -
Abstract: This amendment defines modifications to both the IEEE 802.11 physical layer (PHY) and the IEEE 802.11 medium access control (MAC) sublayer for wake-up radio operation. (The PDF of this standard is available at no cost to ...Subject(s) : power save , PHY , physical layer , medium access control , IEEE 802.11ba , wake-up radio , IEEE 802.11 , MAC , -
IEEE Guide for DC Inclined Plane Tracking and Erosion Test for Outdoor Insulation Applications
Abstract: This guide is intended for a suitable use of dc voltages with the inclined plane tracking and erosion test for the evaluation of the tracking and erosion resistance of high voltage outdoor insulating materials.Subject(s) : inclined plane tracking and erosion test , erosion test , IEEE 2652 , tracking and erosion resistances , screening test , outdoor insulating materials , dc applications , -
IEEE/ISO/IEC International Standard - International Standard-Telecommunications and exchange between information technology systems — Requirements for local and metropolitan area networks —Part 1AX: Link aggregation
Abstract: Link Aggregation allows parallel point-to-point links to be used as if they were a single link and also supports the use of multiple links as a resilient load-sharing interconnect between multiple nodes in two separately ...Subject(s) : Distributed Resilient Network Interconnect , Aggregated Link , Aggregator , local area network , Network-Network Interface , NNI , interconnect , DRNI , Link Aggregation , management , Link Aggregation Group , -
IEEE/ISO/IEC International Standard-Telecommunications and exchange between information technology systems — Requirements for local and metropolitan area networks — Part 1Q: Bridges and bridged networks AMENDMENT 2: YANG data model
Abstract: A YANG data model in support of configuration and operational status information for a subset of Bridging capabilities is provided in this amendment to IEEE Std 802.1Q(TM)-2018.Subject(s) : IEEE 802.1Q™ , Virtual Bridged Local Area Networks (virtual LANs) , YANG , local area networks (LANs) , IEEE 802.1Qcp™ , IEEE 802® , metropolitan area networks , MAC Bridges , Bridged Local Area Networks , -
ISO/IEC/IEEE International Standard - Telecommunications and exchange between information technology systems — Requirements for local and metropolitan area networks —Part 1Q: Bridges and bridged networks AMENDMENT 3: Virtual station interface (VSI) discov
Abstract: Extensions to the Virtual Station Interface (VSI) Discovery and Configuration Protocol (VDP) to support using the protocol between an end station and a device doing encapsulation/decapsulation for Network Virtualization ...Subject(s) : amendment , IEEE 802.1Qcy™ , IEEE 802.1Q™ , VDP IP address extension , VDP extension , NVO3 , -
IEEE Recommended Practice for Vital Computer for Rail Safety-Related Application
Abstract: Requirements for functions, performance, and interface and environmental conditions for vital computers used in rail safety-related systems are established in this recommended practice. Vital computer functions are developed ...Subject(s) : IEEE 2839 , RAMS , rail safety-related system , fail-safe , vital computer , SIL , safety ,