درباره ما
ARMY - AT - Tank-Automotive and Armaments Command: Recent submissions
Now showing items 221-240 of 832
-
MIL-HDBK-767
Abstract: Techniques available to reduce interior noise in light-armored tracked vehicles are discussed. Emphasis is on those sources that have their major effect on interior noise. Exterior noise is addressed only as a result of ...Subject(s) : Acoustics , Auditory detection , Chordal action , Damping , Drive sprocket , Engine , Final drive , Hearing hazard , Hull , Idler wheel , Interior acoustics , Measurement errors , Microphone , Modal analysis , Power train , Radiation efficiency , Road wheel , Speech intelligibility , Sprocket wheel , Support roller , Track , Vibration , Window analysis , -
A-A-52406B
Abstract: This CID covers standard and heavy duty muffler loop clamps of various sizes. The muffler loop clamps are hereinafter referred to as clamps. -
A-A-59464A VALID NOTICE 1
Abstract: This CID covers plastisol for general hot dip applications.Subject(s) : Formulated coatings , Grips , Handles , Vinyl dip , -
MIL-M-12185C
Abstract: This specification covers air and vacuum windshield wiper motors and windshield wiper motor shut-off and speed control valves for use on military vehicles. Intended Use: The windshield wiper motors and control ... -
A-A-52474B
Abstract: This CID covers a water borne, cathodic epoxy electrodeposition primer (herein after referred to as primer) intended for use on cleaned and pretreated steel, galvanized steel, and aluminum. The primer meets solvent emission ... -
A-A-52530
Abstract: This CID covers requirements for a type of reformulated unleaded automotive gasoline containing ethyl alcohol (ethanol) as the oxygenate. Gasohol meets the oxygenate requirements for use in carbon monoxide nonattainment ... -
MIL-DTL-45859D
Abstract: This specification covers a pneumatic pop-valve-test bench assembly for testing air-compressor components at pressures up to 6000 pounds per square inch gage (psig). Intended Use: The bench assembly covered ...Subject(s) : Air compressor , Compressor components , Gages , Hoses , Pneumatic , -
MIL-DTL-4M
Abstract: This specification covers the preservative, packing, and marking for shipment and storage of: Vehicle (non-aircraft) tires, pneumatic; inner tubes, pneumatic tires; and tires with flaps. Intended Use: The ...Subject(s) : Flap , Intermediate container , Preservation , Shipment , Storage , Unitization , -
MIL-PRF-52747F
Abstract: This specification covers two types of closed-circuit fuel servicing nozzle assemblies. Intended Use: This nozzle is intended for use with fuel dispensing systems to safely deliver contaminant-free fuel to ...Subject(s) : Adapter , Aircraft , Dispensing , Fuel , Servicing ,