درباره ما
Browsing ECIA - Electronic Components Industry Association by Title
Now showing items 1-20 of 507
-
ECA 153-B
Abstract: This standard outlines electrical, mechanical, and environmental requirements for commercial capacitors which have a natural mica dielectric and wire lead terminations.
It is a standard covering a variety of case sizes, ... -
ECA 172-B
Abstract: This standard covers insulated, fixed resistors having a composition resistance element and capable of full load operation at an ambient temperature of 70°C. This standard describes minimum *limits of performance ... -
ECA 180
Abstract: This specification covers iron core, power transformers up to 10 KVA for use in electronic equipment where long life, reliability and continuity of operation is essential. -
ECA 181
Abstract: This standard covers iron core charging reactors for use in radar transmitters and similar equipment where long life, reliability and continuity of operation is essentiai. -
ECA 186-10E
Abstract: PURPOSE
This test is performed to determine the effect of normal soldering operations on component parts. Excessive changes in electrical characteristics or mechanical damage to a component part are ... -
ECA 186-11E
Abstract: PURPOSE
This test is conducted for the purpose of determining the resistance of a component part to exposures at ! extremes of high and low temperatures in air, and to the shock of alternate exposures ... -
ECA 186-12E
Abstract: PURPOSE
This test is performed to determine the effect of storing or operating component parts at elevated temperatures for various time periods. Different degrees of severity as prescribed by temperature ... -
ECA 186-13E
Abstract: PURPOSE
This test is to measure the resistance offered by the insulating members of a component part to an impressed direct voltage tending to produce a leakage of current through or on the surface of ... -
ECA 186-14E
Abstract: PURPOSE
This test is intended to determine the effectiveness of panel seals on electronic components which are intended for mounting through holes in panels or enclosures. The panel seals are exposed to water under ... -
ECA 186-1E
Abstract: PURPOSE
This test is intended to evaluate the effect of absorption and diffusion of moisture and moisture vapor on component parts. The test in an artificial environmental test, accelerated to shorten ... -
ECA 186-2E
Abstract: PURPOSE
This test is intended to evaluate in an accelerated manner, the resistance of component parts to deterioration resulting from high humidity and heat conditions typical of tropical environments. ... -
ECA 186-3E
Abstract: PURPOSE
This test is intended to evaluate the effect of absorption and diffusion of moisture and moisture vapor on component parts. The test is an artificial environmental test and is severely accelerated ... -
ECA 186-4E
Abstract: PURPOSE
This dielectric test is performed for the purpose of determining the ability of component parts to withstand a potential at sea level or at a specified altitude. The potential used is normally ... -
ECA 186-5E
Abstract: PURPOSE
The salt spray test is performed for the purpose of determining the adequacy of protective coatings or finishes, and has been widely used to evaluate the resistance of metals to corrosion in ... -
ECA 186-6E
Abstract: PURPOSE
These tests are intended to determine the ability of terminals to withstand the usual stresses which may be applied during assembly or disassembly operations. Several types of tests are provided ... -
ECA 186-7E
Abstract: PURPOSE
This vibration fatigue test is performed for the purpose of determining the ability of component parts and their mountings to withstand vibration in the low frequency range of 10 to 55 Hertz. ... -
ECA 186-8E
Abstract: PURPOSE
This sinusoidal high frequency vibration test is performed for the purpose of determining the effect on component parts of vibration in the frequency range of 10 to 500 Hz or 10 to 2000 Hz as ... -
ECA 186-9E
Abstract: This standard defines a test for solderability of solid lead wires, terminals, and conductive accessories of component parts which are to be joined by a soldering operation involving the use of rosin type flux and solder ...