درباره ما
ISO - International Organization for Standardization: Recent submissions
Now showing items 741-760 of 21282
-
ISO 5129
Abstract: This International Standard specifies requirements for instruments and test procedures for the measurement and reporting of sound pressure levels at crew and passenger locations in the interior of aircraft under steady ... -
ISO 5832-2
Abstract: This part of ISO 5832 specifies the characteristics of, and corresponding test methods for, unalloyed titanium for use in the manufacture of surgical implants.
Provision is made for six grades of titanium based on ... -
ISO 8536-3
Abstract: This part of ISO 8536 specifies aluminium caps for infusion glass bottles which are in accordance with ISO 8536-1. -
ISO 8536-11
Abstract: This part of ISO 8536 applies to sterilized infusion filters for single use up to 200 kPa (2 bar) on fluid lines of pressure infusion equipment and infusion set as specified in ISO 8536-8. It does not include the effectiveness ... -
ISO 27729
Abstract: This International Standard specifies the International Standard name identifier (ISNI) for the identification of public identities of parties, i.e. the identities used publicly by parties involved throughout the media ... -
ISO ISO/IEC 24771
Abstract: This International Standard defines a protocol for the physical layer (PHY) and the data link layer in order to construct a reliable and high-speed data transmission network between devices on industrial sites such as ... -
ISO 362-2
Abstract: This part of ISO 362 specifies an engineering method for measuring the noise emitted by road vehicles of categories L3, L4 and L5 under typical urban traffic conditions. It excludes vehicles of category L1 and L2, which ... -
ISO 17261
Abstract: This International Standard describes the conceptual and logical architecture for automatic vehicle and equipment identification (AVI/AEI) and supporting services in an intermodal/multimodal environment.
It presents a ... -
ISO TS 16403-2
Abstract: The objective of this part of ISO/TS 16403 is to provide a basis for conformance tests for Front End and Back End in electronic fee collection, based on autonomous on-board equipment. This supports interoperability between ... -
ISO 1628-3
Abstract: This part of ISO 1628 defines particular conditions for determining the reduced viscosity (also known as viscosity number) and intrinsic viscosity of polyethylenes and polypropylenes at 135 °C in dilute solution. ... -
ISO 26432-2
Abstract: This guideline addresses interoperability of equipment from the standpoint of the frequency response of filters used in the playback or monitor path in the theater LFE channel for digital cinema. This response curve will ... -
ISO ISO/IEC 19757-3
Abstract: This part of ISO/IEC 19757 specifies Schematron, a schema language for XML. This part of ISO/IEC 19757 establishes requirements for Schematron schemas and specifies when an XML document matches the patterns specified by a ...