درباره ما
ISO - International Organization for Standardization: Recent submissions
Now showing items 781-800 of 21282
-
ISO 5610-15
Abstract: This part of ISO 5610 specifies tool holders with rectangular shank, style V, i.e. with offset shank and cutting edge angle κr = 72,5° for side cutting.
These tool holders are primarily ... -
ISO 10504
Abstract: This International Standard describes a high-performance liquid chromatographic (HPLC) method for measuring the composition of dextrose solutions, glucose syrups, fructose-containing syrups, hydrogenated glucose syrups, ... -
ISO DIS 17554
Abstract: This International Standard specifies a small-scale method for assessing the mass loss rate of essentially flat specimens exposed in the horizontal orientation to controlled levels of radiant heating with an external igniter ... -
ISO ISO/IEC TR 26927
Abstract: Mobility for enterprise communications is the ability for persons and objects (e.g. vehicles, sensors and other machines) belonging to the enterprise to use communication and information services regardless of changes in ... -
ISO DIS 7500-1
Abstract: This part of ISO 7500 specifies the verification of tension/compression testing machines.
The verification consists of
- a general inspection of the testing machine, including its accessories for the force application; ... -
ISO 16120-3
Abstract: This part of ISO 16120 is applicable to wire rod made of low-carbon, low-silicon, rimmed and rimmed substitute steel with high ductility intended for drawing and/or cold rolling. -
ISO ISO/IEC TR 15504-7
Abstract: This part of ISO/IEC 15504 addresses the expression of the results of assessment of processes in terms of the overall maturity of an organizational unit, and the application of the results of assessment of organizational ... -
ISO 4757
Abstract: Scope and field of application
This International Standard defines two types of cross recesses for screws:
- recess type H ;
- recess type Z.
Included in this International Standard is a ... -
ISO 11999-1
Abstract: This International Standard specifies minimum design and performance requirements for personal protective equipment (PPE) to be used by firefighters, primarily but not solely to protect against exposure to flame and high ... -
ISO FDIS 13935-1
Abstract: This part of ISO 13935 specifies a procedure to determine the seam maximum force of sewn seams when the force is applied perpendicularly to the seam. This part of ISO 13935 specifies the method known as the strip test. ... -
ISO 11783-12
Abstract: ISO 11783, as a whole, specifies a serial data network for control and communications on forestry or agricultural tractors and mounted, semi-mounted, towed, or self-propelled implements. Its purpose is to standardize the ... -
ISO 28005-2
Abstract: General
This part of ISO 28005 contains technical specifications that facilitate efficient exchange of electronic information between ships and shore for coastal transit or port calls. It is intended ... -
ISO 4628-4
Abstract: This part of ISO 4628 describes a method for assessing the degree of cracking of coatings by comparison with pictorial standards, using the designation system defined in ISO 4628-1.
ISO 4628-1 defines the system used ... -
ISO 16835
Abstract: This International Standard specifies test methods for the thermal expansion of refractory products. It describes a method for determining the linear thermal expansion percentage, the linear thermal expansion curve, and ...