درباره ما
Standard Guide for Hot Isostatic Pressing (HIP) of Aluminum Alloy Castings
ASTM B998-17
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 4.1 HIP of castings should be performed in the as cast condition. Post HIP inspection of castings should result in a reduction of porosity that is evident in x-ray grade and properties. 4.2 HIP will not eliminate inclusions or surface-connected porosity in a casting.
Collections
:
-
Statistics
Standard Guide for Hot Isostatic Pressing (HIP) of Aluminum Alloy Castings
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2024-12-17T23:29:33Z | |
| date available | 2024-12-17T23:29:33Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | B0998-17r24.pdf | |
| identifier uri | http://yse.yabesh.ir/std;query=author:%22NAVY%20-%20YD%20-%20Naval%20Facilities%20Engineering%20Command%22/handle/yse/337917 | |
| description abstract | 4.1 HIP of castings should be performed in the as cast condition. Post HIP inspection of castings should result in a reduction of porosity that is evident in x-ray grade and properties. 4.2 HIP will not eliminate inclusions or surface-connected porosity in a casting. | |
| language | English | |
| title | Standard Guide for Hot Isostatic Pressing (HIP) of Aluminum Alloy Castings | en |
| title | ASTM B998-17 | num |
| type | standard | |
| page | 4 | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This guide covers requirements for hot isostatic pressing (HIP) of aluminum alloy castings. HIPing is a process in which components are subjected to the simultaneous application of heat and high pressure in an inert gas medium. The process is to be used for the reduction of internal (non-surface connected) porosity. The document is to describe the general parameters of the HIP process, describe certification procedures and a description that the process has been followed. It is not intended to be a description of a heat treating procedure. This is not meant to supersede an end user’s specification where one exists.2 1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0998-17R24 |