درباره ما
UFC - Unified Facilities Criteria: Recent submissions
Now showing items 101-120 of 255
-
UFC 4-133-01N CHANGE 4 AND 5
Abstract: This Unified Facilities Criteria (UFC), UFC 4-133-01, contains guidance for (Navy and contract) planners, engineers, and architects on the planning, engineering, and design of Department of the Navy (DoN) air traffic control ... -
UFC 4-740-10AN
Abstract: Purpose
a. This guide contains design criteria for Army Auto Crafts Centers which are in some instances referred to as Automotive Self-Help Garages. The term Automotive Self-Help Garage will be used only when ... -
UFC 3-230-06A CHANGE 2
Abstract: The criteria herein apply to paved areas such as airfields, roads, streets and parking lots having a relatively impervious surface such as asphalt concrete or Portland cement concrete. The criteria is limited to situations ... -
UFC 4-721-01A
Abstract: PURPOSE.
These Architectural and Engineering Instructions (AEI) provide design policy and technical guidance for design and engineering services in support of the Barracks Upgrade Program (BUP) for ... -
UFC 4-213-12
Abstract: This UFC presents drydocking facilities characteristics in tabular and figure form for graving drydocks, marine railways and lifts. Plans are also presented indicating the locations of drydocking facilities in naval shipyards ... -
UFC 3-260-17
Abstract: PurposeThis manual provides guidance for dust control methods and materials that can be used successfully at airfields and heliports to stop dust from forming naturally or as a result of man’s ... -
UFC 3-340-07AN
Abstract: FOREWORD
The Unified Facilities Criteria (UFC) system is prescribed by MIL-STD 3007 and provides planning, design, construction, sustainment, restoration, and modernization criteria, and applies to the ... -
UFC 3-220-06
Abstract: PURPOSE AND SCOPE. This manual was prepared to provide guidance in the use of pressure grouting as a means to correct existing or anticipated subsurface problems. Information on procedures, materials, and equipment for use ... -
UFC 3-220-10N CHANGE 1
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC. Appendix A contains the full text copy of DM 7.01.
APPLICABILITY.
This UFC applies to all ... -
UFC 3-270-02
Abstract: This handbook contains information on materials, equipment, and procedures used to clean and seal cracks in asphalt cement concrete pavements. Crack repair problem areas are also presented. Additional information can be ... -
UFC 3-310-03A
Abstract: Purpose and Scope.
This document is intended to provide qualified designers with the necessary criteria and guidance for the performance-based seismic analysis and design of new military buildings, and the nonstructural ... -
UFC 3-220-01A
Abstract: General information with respect to the selection and design of deep foundations is addressed herein. Single and groups of driven piles and drilled shafts under axial and lateral static loads are treated. Some example ... -
UFC 3-410-05N CHANGE 1
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service documents closely related to the subject. Appendix A ... -
UFC 4-150-07
Abstract: This military handbook, UFC 4-150-07, is a guide for the inspection, maintenance, and repair of waterfront structures and related facilities. It is a source of reference for planning, estimating, and performing technical ... -
UFC 4-141-04 CHANGE 1
Abstract: PURPOSE AND SCOPE.
This document presents a unified approach for the planning and design of Emergency Operation Centers (EOCs). This document is not intended to establish the requirement for an EOC or ... -
UFC 3-530-01 CHANGE 1
Abstract: PURPOSE AND SCOPE.
This UFC provides guidance for the design of interior and exterior lighting systems and controls based on the Illuminating Engineering Society of North America's (IESNA) Lighting ... -
UFC 3-240-14N CHANGE 1
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service documents closely related to the subject. Appendix A ... -
UFC 1-300-02 CHANGE 4
Abstract: PURPOSE AND SCOPE
This UFC provides guidance for the preparation of Unified Facilities Guide Specifications (UFGS). UFGS are published by the Services under the auspices of the Tri-Service Engineering ... -
UFC 4-310-02N
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service documents closely related to the subject. Appendix A ... -
UFC 3-250-10FA
Abstract: The elastic layered procedure is used to determine thickness requirements of flexible and rigid pavement structures subject to vehicular traffic loads. This manual treats the thickness design of concrete pavements (both ...