درباره ما
API - American Petroleum Institute: Recent submissions
Now showing items 1001-1020 of 1822
-
API MPMS 14.3.2
Abstract: FOREWORD
This foreword is for information and is not part of this standard. Chapter 14, Section 3, Part 2, of the Manual of Petroleum Measurement Standards furnishes the specifications and ... -
API RP 10B-5
Abstract: This part of ISO 10426 provides the methods for the testing of well cement formulations to determine the dimension changes during the curing process (cement hydration) at atmospheric pressure only. This is a base document, ... -
API RP 44
Abstract: Proper management of production from a natural gas or petroleum reservoir can maximize the recovery of the hydrocarbon fluids (gas and oil) originally in the reservoir. Developing proper management strategies requires ... -
API RP 5A5
Abstract: This International Standard specifies requirements and gives recommendations for field inspection and testing of oil country tubular goods (OCTG). This International Standard covers the practices and technology commonly ... -
API RP 14E
Abstract: This document recommends minimum requirements and guidelines for the design and installation of new piping systems on production platforms located offshore. The maximum design pressure within the scope of this document is ... -
API MPMS 1
Abstract: The words and terms contained in this vocabulary are defined and described to assist in understanding their use throughout the entire API Manual of Petroleum Measurement Standards (MPMS).
Additional sections ... -
API STD 613
Abstract: This standard covers the minimum requirements for special-purpose, enclosed, precision single- and double-helical one- and two-stage speed increasers and reducers of parallelshaft design for petroleum, chemical and gas ... -
API STD 5T1
Abstract: The purpose of this standard is to provide definitions of imperfections and defects that occur in steel pipe; no criteria as to severity are addressed. The word imperfection as used herein refers to metallurgical ... -
API MPMS 14.3.3
Abstract: General
This part of Chapter 14, Section 3, has been developed as an application guide for the calculation of natural gas flow through a flange-tapped, concentric orifice meter, using the inch-pound ... -
API MPMS 6.2
Abstract: Scope of Application
This standard offers guidance on the design, selection, and operation of loading rack metering systems and associated equipment where liquid hydrocarbons are loaded into vehicle tanks. -
API STD 673
Abstract: This standard covers the minimum requirements for centrifugal fans for use in petroleum, chemical, and gas industry services. Fan static pressure rise is limited to differential usually not exceeding 130 in. (330 cm) of ... -
API STD 616
Abstract: General
This standard covers the minimum requirements for open, simple, and regenerative-cycle combustion gas turbine units for services of mechanical drive, generator drive, or process gas generation. ... -
API SPEC 2B
Abstract: This specification covers the fabrication of structural steel pipe formed from plate steel with longitudinal and circumferential butt-welded seams, typically in sizes 14 in. outside diameter (OD) and larger (40 in. and ... -
API RP 1115
Abstract: This recommended practice provides basic guidance on the operation of solution-mined underground hydrocarbon liquid or liquefied petroleum gas storage facilities. This document is intended for first-time cavern engineers ... -
API PUBL 4601
Abstract: Scope:
BACKGROUND
This report presents the findings of a natural gradient tracer test and related laboratory experiments that investigate the subsurface behavior and ... -
API PUBL 4653
Abstract: Ten pipeline facilities located across the United States of America (USA) were selected for the project. All components in use except those on tank tops were inventoried and screened using EPA Method 21 guidelines. ...