درباره ما
API - American Petroleum Institute: Recent submissions
Now showing items 1441-1460 of 1822
-
API TR 2568
Abstract: INTRODUCTION
This report provides guidance for estimating emissions that result from removing the liquid heel (free-standing stock liquid) and cleaning the remaining deposits of stock liquid mixed with ... -
API PUBL 4751
Abstract: Introduction
This report presents an overview and discussion of the use of the ambient water quality criterion for methylmercury developed by the U.S. Environmental Protection Agency (EPA) in 2001 (66 ... -
API STD 617
Abstract: This standard covers the minimum requirements for axial compressors, single-shaft and integrally geared process centrifugal compressors and expander-compressor for use in the petroleum, chemical, and gas industries services ... -
API RP 15CLT
Abstract: This recommended practice (RP) provides guidelines for the design, manufacture, qualification and application of composite lined carbon steel downhole tubing in the handling and transport of multiphase fluids, hydrocarbon ... -
API PUBL 4758
Abstract: PURPOSE OF THIS GUIDE
The exploration and production (E&P) industry uses great care during the handling and disposal of the produced water that is generated as part of oil and gas production. However, ... -
API RP 17A
Abstract: This part of ISO 13628 provides general requirements and overall recommendations for development of complete subsea production systems, from the design phase to decommissioning and abandonment. This part of ISO 13628 is ... -
API STD 17O
Abstract: This standard addresses the requirements for the use of high integrity pressure protection systems (HIPPS) for subsea applications. API 14C, IEC 61508, and IEC 61511 specify the requirements for onshore, topsides, and ... -
API TR 411
Abstract: Scope:
FOREWORD
API PUBLICATIONS NECESSARILY ADDRESS PROBLEMS OF A GENERAL NATURE. WITH RESPECT TO PARTICULAR CIRCUMSTANCES, LOCAL, STATE, AND FEDERAL LAWS AND REGULATIONS ... -
API RP 6DR
Abstract: This recommended practice provides guidelines for the repair and remanufacture of steel ball, check, gate, and plug valves normally used in pipeline applications, as defined by API 6D.
This recommended practice covers ... -
API MPMS 2.2B
Abstract: This standard describes measurement and calculation procedures for determining the diameters of upright welded (lap/butt) cylindrical tanks, or vertical cylindrical tanks, with a smooth outside surface and either floating ... -
API MPMS 4.9.4
Abstract: General
This standard covers the specific procedures, equipment, and calculations required to determine the Base Prover Volume (BPV), of both tank and displacement provers by the gravimetric method of ... -
API STD 53
Abstract: Purpose
The purpose of this standard is to provide requirements on the installation and testing of blowout prevention equipment systems on land and marine drilling rigs (barge, platform, ... -
API RP 751
Abstract: The refining industry has long demonstrated that HF acid alkylation units can be operated safely and responsibly. Like many industrial processes, the HF acid alkylation process presents operational risk and must be properly ... -
API MPMS 10.8
Abstract: This test method covers the determination of sediment in crude oils by membrane filtration. This test method has been validated for crude oils with sediments up to approximately 0.15 mass %.
The accepted unit of measure ...Subject(s) : crude oil , membrane filtration , sediment , -
API PUBL 4668
Abstract: FOREWORD
API PUBLICATIONS NECESSARILY ADDRESS PROBLEMS OF A GENERAL NATURE. WITH RESPECT TO PARTICULAR CIRCUMSTANCES, LOCAL, STATE, AND FEDERAL LAWS AND REGULATIONS SHOULD BE REVIEWED.
API IS NOT ...