درباره ما
API - American Petroleum Institute: Recent submissions
Now showing items 661-680 of 1822
-
API RP 576
Abstract: This recommended practice (RP) describes the inspection and repair practices for automatic pressure-relieving devices commonly used in the oil and petrochemical industries. As a guide to the inspection and repair of these ... -
API MPMS 10.1
Abstract: This test method covers the determination of sediment in crude oils and fuel oils by extraction with toluene. The precision applies to a range of sediment levels from 0.01 to 0.40 % mass, although higher levels may be ... -
API STD 608 RUSSIAN
Abstract: This standard covers metal ball valves used in on-off service that have butt-welding or flanged ends for nominal pipe size ½ through NPS 12 and threaded or socket-welding ends for sizes NPS ½ through NPS 2, ... -
API PUBL 4698
Abstract: FOREWORD
API PUBLICATIONS NECESSARILY ADDRESS PROBLEMS OF A GENERAL NATURE. WITH RESPECT TO PARTICULAR CIRCUMSTANCES, LOCAL, STATE, AND FEDERAL LAWS AND REGULATIONS SHOULD BE REVIEWED.
API IS NOT ... -
API RP 10F
Abstract: This International Standard describes testing practices to evaluate the performance of cementing float equipment for the petroleum and natural gas industries.
This International Standard is applicable to float equipment ... -
API PUBL 4619
Abstract: Scope:
FOREWORD
API PUBLICATIONS NECESSARILY ADDRESS PROBLEMS OF A GENERAL NATURE. WITH RESPECT TO PARTICULAR CIRCUMSTANCES, LOCAL, STATE, AND FEDERAL LAWS AND REGULATIONS ... -
API MPMS 11.2.2
Abstract: The purpose of this standard is to correct hydrocarbon volumes metered under pressure to the corresponding volumes at the equilibrium pressure for the metered temperature. This standard contains compressibility factors ... -
API MPMS 7.3
Abstract: This standard describes the methods, equipment, and procedures for determining the temperature of petroleum and petroleum products under static conditions by the use of an automatic method. Automatic temperature measurement ... -
API RP 15TL4
Abstract: The purpose of this publication is to provide information on the transporting, handling, installing, and reconditioning of fiberglass tubulars in oilfield usage.
Note: No provision of this Recommended Practice shall ... -
API RP 1169
Abstract: This recommended practice (RP) covers the basic requirements and their associated references needed to perform inspection activities safely and effectively during construction of new onshore pipelines. Use of this document ... -
API STD 65-2
Abstract: Overview
This standard contains practices for isolating potential flow zones, an integral element in maintaining well integrity. The focus of this standard is the prevention of flow through or past ... -
API PUBL 4703
Abstract: Scope:
In 1997, the United States Environmental Protection Agency (EPA) promulgated new ambient air standards for particulate matter smaller than 2.5 micrometers in diameter ... -
API MPMS 8.2
Abstract: This standard provides information for the design, installation, testing, and operation of automated equipment for extraction of representative samples of petroleum and petroleum products from a flowing stream and storing ... -
API PUBL 4681
Abstract: FOREWORD
API PUBLICATIONS NECESSARILY ADDRESS PROBLEMS OF A GENERAL NATURE. WITH RESPECT TO PARTICULAR CIRCUMSTANCES, LOCAL, STATE, AND FEDERAL, LAWS AND REGULATIONS SHOULD BE REVIEWED.
API IS NOT UNDERTAKING ... -
API SPEC 15HR ERTA 2
Abstract: Scope
PURPOSE
This specification was formulated to provide for the availability of safe, dimensionally and functionally interchangeable high pressure fiberglass line pipe with a Specification 15HR ... -
API STD 521
Abstract: This International Standard is applicable to pressure-relieving and vapour-depressuring systems. Although intended for use primarily in oil refineries, it is also applicable to petrochemical facilities, gas plants, liquefied ... -
API RP 14F
Abstract: This document recommends minimum requirements and guidelines for the design, installation, and maintenance of electrical systems on fixed and floating petroleum facilities located offshore. For facilities classified as ...