درباره ما
API - American Petroleum Institute: Recent submissions
Now showing items 941-960 of 1822
-
API RP 5LW
Abstract: The recommendations in this document apply to transportation of API Specification 5L steel line pipe by ship or barge on both inland and marine waterways, unless the specific requirement of a paragraph in this document ... -
API SPEC 12P
Abstract: General
This specification covers material, design, fabrication, and testing requirements for fiberglass reinforced plastic (FRP) tanks. Only shop-fabricated, vertical, cylindrical tanks are covered. ... -
API RP 13B-2
Abstract: This recommended practice provides standard procedures for determining the following characteristics of oilbased drilling fluids:
a) drilling fluid density (mud weight);
b) viscosity and gel strength;
c) ... -
API PUBL 939-A
Abstract: Scope:
FOREWORD
In 1990 cracking of refinery process equipment in wet H2S service was being widely reported. As a result, committees and task groups of industry ... -
API RP 686
Abstract: Purpose
This recommended practice (RP) is intended to provide recommended procedures, practices, and checklists for the installation and precommissioning of new, existing, and reapplied machinery and ... -
API SPEC 9A
Abstract: This standard specifies the minimum requirements and terms of acceptance for the manufacture and testing of steel wire ropes not exceeding rope grade 2160 for the petroleum and natural gas industries. The following products ... -
API MPMS 12.1.2
Abstract: This Chapter is applicable to all crude oils, petroleum products, and petrochemicals (including LPGs and other liquefied gases) transported by rail tank car. It does not cover any products loaded or measured as solids. It ... -
API TR 941
Abstract: ABSTRACT
Reports covering a half-century of comprehensive research on hydrogen attack have been reviewed. The major investigators were found to agree about what information would be needed to model the ... -
API MPMS 10.6
Abstract: This test method describes the laboratory determination of water and sediment in fuel oils in the range from 0 to 30 % volume by means of the centrifuge procedure.
NOTE 1—With some types of fuel oils such as ... -
API MPMS 5.1
Abstract: API MPMS Chapter 5 is intended to be a guide for the proper specification, installation, and operation of meter stations designed to dynamically measure liquid hydrocarbons so that acceptable accuracy, service life, safety, ... -
API MPMS 17.2 SPANISH
Abstract: Objetivo
EI objective de esta publicatión es servir de guía al personal de buque y de tierra en cuanto a los métodos ... -
API MPMS 18.1
Abstract: Scope and Field of Application
These procedures are organized into a recommended sequence of steps for manually determining the quantity and quality of crude oil being transferred under field conditions. ... -
API PUBL 7105
Abstract: 1.2 OBJECTIVE AND SCOPE
The objective of the work described in this report was to prepare a brief technical analysis of the radium concentration limit of 30 pCi/g in pipe scale and sludge left near the surface ... -
API MPMS 17.9
Abstract: This standard provides a recommended practice for the calculation and application of a VEF and provides guidelines for data compilation, data validation, and recommendations on the appropriate use of VEF during custody ...