IEEE - The Institute of Electrical and Electronics Engineers, Inc.: Recent submissions

Now showing items 2341-2360 of 2832

    • IEEE C63.18 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;1997
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Foreword
      This recommended practice was developed over a period of two years (1995˘1997) in response to a need expressed by clinical and biomedical engineers for a technical guide to aid them in assessing the immunity ...

    • IEEE C93.1 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;1999
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard applies to capacitors for coupling power-line carriers and for reducing rate of rise of breaker transient recovery voltage, and to coupling capacitor voltage transformers (CCVT) for connection to a high voltage ...

    • IEEE 1484.12.3 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2005
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Foreword
      This Standard defines World Wide Web Consortium (W3C) Extensible Markup Language (XML) structure and constraints on the contents of XML 1.1 documents that can be used to represent learning ...

    • IEEE 802.21A 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2012
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: General
      Change the list in 1.3 as follows:
      The following items are not within the scope of this standard:
      — Intra-technology handover [except for handovers across extended ...
      Subject(s) : IEEE 802.21 , IEEE 802.21a , proactive authentication , security protection , service access authentication ,

    • IEEE P802.11AC/D5.0 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2013
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: The purpose of the amendment is to improve the 802.11 wireless local area network (LAN) user experience by providing significantly higher basic service set (BSS) throughput for existing WLAN application areas and to enable ...

    • IEEE N42.30 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2002
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Foreword
      The performance requirements for tritium monitors used for monitoring airborne tritium radioactivity are provided in this standard. It also provides test methods for establishing a monitor’s performance ...

    • IEEE 1232 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2010
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: The AI-ESTATE standard defines formal specifications for supporting system diagnosis. These specifications support the exchange and processing of diagnostic information and the control of diagnostic processes. Diagnostic ...
      Subject(s) : AI-ESTATE , Bayesian Network , diagnosis , diagnostic inference , diagnostic model , diagnostic services , D-matrix , fault tree , IEEE 1232 , knowledge exchange , system test ,

    • IEEE 807 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2011
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This recommended practice provides a unique identification system for hydro facilities that segregates and incorporates plant, unit, system, and component identifiers as a minimum. 
      Purpose
      This ...
      Subject(s) : coding , component , device , identification , IEEE 807 , reporting , tagging ,

    • IEEE 738 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2006
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: The purpose of this standard is to present a method of calculating the current-temperature relationship of bare overhead conductors.
      Conductor surface temperatures are a function of the following:
      a) Conductor ...
      Subject(s) : bare overhead lines , current-temperature relationship ,

    • IEEE 1122 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2007
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard is applicable to digital recorders and digital oscilloscopes used for measurements during tests with high-impulse voltages and high-impulse currents. It covers the measuring characteristics and calibrations ...

    • IEEE 80005-1 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2012
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This part of IEC 80005 describes high voltage shore connection (HVSC) systems, on board the ship and on shore, to supply the ship with electrical power from shore.
      This standard is applicable to the design, installation ...

    • IEEE C37.06.1 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2000
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Foreword
      Following reports of circuit breaker failures in applications where very fast TRVs were determined to be the cause, and after thorough analysis of TRV data gathered from all parts of the world, this guide was ...

    • IEEE C37.30 INT 1 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2011
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Overview
      This standard applies to all high-voltage enclosed indoor or outdoor, and non-enclosed indoor or outdoor, switches rated in excess of 1000 V. This includes such switch types as disconnecting, ...
      Subject(s) : high-voltage switches ,

    • IEEE 1671.4 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2007
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.

    • IEEE 1450.6.1 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2009
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.

    • IEEE C57.113 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2010
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This recommended practice describes the test procedure for the detection and measurement by the wideband apparent charge method of partial discharges (PDs) occurring in liquid-filled power transformers and shunt reactors ...
      Subject(s) : apparent charge , IEEE C57.113 , partial discharge (PD) , power transformer , shunt reactor , wideband PD measurement ,

    • IEEE 1220 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2005
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This standard defines the interdisciplinary tasks that are required throughout a system's life cycle to transform stakeholder needs, requirements, and constraints into a system solution. This standard is intended to guide ...
      Subject(s) : acquire , analysis , architecture , building block , component , design , development , hardware , interface , life cycle processes , software , supplier , synthesis , system , system life cycle , systems engineering , technical management , validation , verification ,

    • IEEE 802.3BK 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2013
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This amendment to IEEE Std 802.3 defines the physical layer specifications and management parameters for EPON operation on point-to-multipoint passive optical networks supporting extended power budget classes of PX30, PX40, ...

    • IEEE C57.12.60 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2009
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: This test procedure for the thermal evaluation of insulation systems of dry-type power and distribution transformers, including both open-wound technology and solid-cast / encapsulated technology is to be used for determining ...
      Subject(s) : insulation systems , model transformer coils , open-wound transformers , resinencapsulated transformers , solid-cast transformers , thermal evaluation ,

    • IEEE 12207 

      Type: standard
      Source: IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2008
      Organization : IEEE - The Institute of Electrical and Electronics Engineers, Inc.
      Abstract: Purpose
      This International Standard establishes a common framework for software life cycle processes, with well-defined terminology, that can be referenced by the software industry. It contains processes, activities, ...