IEEE C62.62

IEEE - The Institute of Electrical and Electronics Engineers, Inc.

Test Specifications for Surge-Protective Devices (SPDs) for Use on the Load Side of the Service Equipment in Low-Voltage (1000 V and Less) AC Power Circuits

Organization:

IEEE - The Institute of Electrical and Electronics Engineers, Inc.

Year: 2010

Abstract: This standard applies to surge-protective devices (SPDs) intended to be installed on the load side of the service equipment connected to 50 Hz or 60 Hz alternating current (ac) power circuits rated at 1000 V (root mean squared [rms]) or less. Performance characteristics and standard methods for testing and rating are established for these devices, which may be composed of any combination of components. The tests in this standard are aimed at providing comparisons among the variety of surge-protective devices available.
Purpose
The purpose of this standard is to provide users, independent laboratories, and manufacturers with test methods and test specifications applicable to low-voltage surge-protective devices used on the load side of the service equipment, intended for limiting transient overvoltages that can appear on ac power circuits of 1000 V (rms) or less.

URI: https://yse.yabesh.ir/std/handle/yse/108751

Subject: C62.62

Collections :

IEEE - The Institute of Electrical and Electronics Engineers, Inc.

Show full item record

contributor author	IEEE - The Institute of Electrical and Electronics Engineers, Inc.
date accessioned	2017-09-04T16:45:27Z
date available	2017-09-04T16:45:27Z
date copyright	40520
date issued	2010
identifier other	VZQTDEAAAAAAAAAA.pdf
identifier uri	https://yse.yabesh.ir/std/handle/yse/108751
description abstract	This standard applies to surge-protective devices (SPDs) intended to be installed on the load side of the service equipment connected to 50 Hz or 60 Hz alternating current (ac) power circuits rated at 1000 V (root mean squared [rms]) or less. Performance characteristics and standard methods for testing and rating are established for these devices, which may be composed of any combination of components. The tests in this standard are aimed at providing comparisons among the variety of surge-protective devices available. Purpose The purpose of this standard is to provide users, independent laboratories, and manufacturers with test methods and test specifications applicable to low-voltage surge-protective devices used on the load side of the service equipment, intended for limiting transient overvoltages that can appear on ac power circuits of 1000 V (rms) or less.
language	English
title	IEEE C62.62	num
title	Test Specifications for Surge-Protective Devices (SPDs) for Use on the Load Side of the Service Equipment in Low-Voltage (1000 V and Less) AC Power Circuits	en
type	standard
page	60
status	Active
tree	IEEE - The Institute of Electrical and Electronics Engineers, Inc.:;2010
contenttype	fulltext
subject keywords	C62.62
subject keywords	combination wave
subject keywords	current-driven test
subject keywords	disconnector
subject keywords	induced failure
subject keywords	maximum continuous operating voltage (MCOV)
subject keywords	nominal discharge current
subject keywords	one-port SPD
subject keywords	operational duty cycle
subject keywords	ring wave
subject keywords	service equipment
subject keywords	short-circuit current rating (SCCR)
subject keywords	SPD Type
subject keywords	surge protection
subject keywords	surge tests
subject keywords	surge-protective device (SPD)
subject keywords	temporary overvoltage (TOV)
subject keywords	transient voltage-surge suppressor (TVSS)
subject keywords	two-port SPD
subject keywords	Type 1 SPD
subject keywords	Type 2 SPD
subject keywords	Type 3 SPD
subject keywords	Type 4 SPD