Abstract: This specification covers metallic-coated steel barbed wire, consisting of a strand of two wires.
The barbed wire is available with aluminum, zinc, and zinc-5 percent aluminum-mischmetal alloy coatings, with a number ...

Abstract: The plastic limit of a soil is the lowest water content determined in accordance with the following procedure at which the soil remains plastic. The plasticity index of a soil is the range in water content, expressed as a ...

Abstract: This specification covers two-component epoxy resin bonding systems for application to portland cement concrete, which are able to cure under humid conditions and bond to damp surfaces.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. Some values have only SI units because the inch-pound equiva...

Abstract: This standard practice covers the annual calibration of the load cell and the deflection sensors and monthly relative calibration of the deflection sensors of a falling weight deflectometer (FWD) or a heavy weight deflectometer (HWD). It is used to establish calibration factors for correcting FWD and HWD measurements.
For this practice, the ter...

Abstract: This specification covers gray iron castings intended for general engineering use where tensile strength is a major consideration. Castings are classified on the basis of the tensile strength of the iron in cast test bars. ...

Abstract: This test method covers the determination of the air content of hydraulic cement mortar under the conditions hereinafter specified.
The values stated in SI units are to be regarded as the standard.
Values in SI shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding in IEEE/ASTM...