درباره ما
NAVY - AS - Naval Air Systems Command: Recent submissions
Now showing items 1961-1980 of 2147
-
MIL-J-8667A
Abstract: This specification establishes the requirements for the design, installation, test and data requirements for Jet Assisted Take-off Systems for Naval aircraft.
JATO unit systems covered by this specification shall be ... -
MIL-STD-287A
Abstract: This standard covers the frequencies and characteristics of signals necessary to properly test TACAN equipment. -
MIL-C-85496
Abstract: This specification establishes the requirements for one type of carbon black. Intended Use: The material described herein is intended to be used as an ingredient in rocket motor case liner formulations. -
MIL-C-18835C
Abstract: This specification covers the assembly, testing, inspection and packing of cartridges for the MK 11 and MK 12 Aircraft Guns. -
MIL-A-85046
Abstract: This specification establishes the requirements for the, manufacture and inspection of one type of electromechanical linear actuator. The test limits in this specification define minimum acceptable capabilities. ... -
MIL-DTL-85405A
Abstract: This specification establishes the requirements for the procurement of a munitions trailer designated as MHU-185/M. Intended Use: The MHU-185/M Munitions Trailer is intended for use at Navy shorebase stations ...Subject(s) : Ammunition , Bombs , Loader , Magazine , Ordnance , Vehicle , Weapons , -
MIL-PRF-7115G
Abstract: This specification establishes the general requirements for converters that convert electrical power in aircraft from nominal 115/200 volts alternating current (AC), 400 Hertz (Hz), AC three-phase, aircraft electrical ... -
MIL-W-6729C
Abstract: This specification covers testing for watertightness and water control of aircraft for rainy weather and aircraft washing. Intended Use: Procedures for testing aircraft described herein are intended to ensure ...Subject(s) : Cockpit , Compartment , Environmentally Secure , Rain Test , Airplane , Rainsoak , Airplane , Water Control , Airplanes & Helicopters , Water Intrusion , Airplanes & Helicopters , -
MIL-C-29600/6
Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense.
The complete requirements for acquiring the stowage receptacles described herein shall consist of this specification ... -
MIL-V-81940/2
Abstract: This specification is approved for use by the USA Belvoir Research and Development Center, Department of the Army, and is available for use by all Departments and Agencies of the Department of Defense.
The complete ... -
A-A-59292
Abstract: This commercial item description (CID) covers reinforced abrasive wheels consisting of aluminum oxide (Al2O3) abrasive particles, non-woven nylon fibers, and a thermosettting resin binder. The wheels ... -
MIL-PRF-22019E (1)
Abstract: This specification establishes the requirements for heat or pressure sealable, transparent, flexible barrier material containing a volatile corrosion inhibitor (VCI) for use in military packaging.Intended Use: ...Subject(s) : Cold-sealable , Heat-sealable , Packaging , Preservation , -
A-A-59315/28
Abstract: This commercial item description sheet (CID), covers a carbon steel-molybdenum-aluminum powder that is applied using either plasma arc or combustion gas (flame spray) techniques. -
MIL-PRF-24021K
Abstract: This specification covers electric power monitors which are installed in aircraft to monitor external electric power to prevent power outside the limits of this specification from being applied to equipment in the aircraft. ...Subject(s) : Alternating current , Direct current , -
A-A-59315/2
Abstract: This commercial item description sheet (CID) covers an aluminum-bronze powder that is applied using either plasma arc or combustion gas (flame spray) techniques. -
MIL-C-85001B
Abstract: This specification establishes the design, performance, and acceptance requirements for the Chaff Roll (Type RR-( )/AL). The chaff (radar reflector) roll or roll set contains components capable of creating confusing ...