درباره ما
MIL-S-24149/4C
STUDS, WELDING, TYPE VI, CLASS 1, 2, 3, CARBON STEEL, FOR STORED ENERGY (CAPACITOR DISCHARGE) ARC WELDING
Year: 1989
Abstract: This specification sheet is approved for use by the Naval Sea Systems Command, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and the issue of the following specification listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation: MIL-S-24149(SH).![FIGURE 1.
Optional weld-end styles.]()
![FIGURE 2.
Type VI, class 1, stud with threaded section.]()
![TABLE I.
Configuration part numbers.]()
![FIGURE 3.
Type VI, class 2, stud with notched end.]()
TABLE II. Length Part numbers.
![FIGURE 4.
Type VI, class 3, stud with grooves (annular rings).]()
TABLE III. Length part numbers.
The requirements for acquiring the product described herein shall consist of this specification sheet and the issue of the following specification listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation: MIL-S-24149(SH).
L M24149/4 ±0.031 dash no. ----------------------------------------- 0.625 -101 .750 -102 .875 -103 1.000 -104 1.125 -105 1.250 -106 1.375 -107 1.500 -108 1.625 -109 1.750 -110 1.875 -111 2.000 -112 2.250 -113 2.500 -114 2.750 -115 3.000 -116 NOTE: 1. Dimensions are in inches. Unless otherwise specified, tolerances: decimals plus or minus 0.015, angles plus or minus 2 degrees.
L M24149/4 ±0.031 dash no. ------------------------------------------------ .625 -201 .750 -202 .875 -203 1.000 -204 1.125 -205 1.250 -206 1.375 -207 1.500 -208 1.625 -209 1.750 -210 1.875 -211 2.000 -212 2.250 -213 2.500 -214 2.750 -215 3.000 -216 NOTE: 1. Dimensions are in inches. Unless otherwise specified, tolerances: decimals plus or minus 0.015, angles plus or minus 1 degree.
Collections
: