درباره ما
GGG-W-648B
WRENCH, LINEMAN'S
Organization:
NAVY - YD - Naval Facilities Engineering Command
Year: 1992
Abstract: This specification covers lineman\'s wrenches used in poleline work. The wrenches were formerly covered by GGG-W-644.
Wrenches shall be of the lineman\'s type and of the following sizes, as specified (see 6.2 and 6.3):
⅝ - (See table I)
¾ - (See table I) Intended Use: The size ⅝ wrench is intended for use on ⅝-inch hardware, and the size ¾ wrench for use on ¾-inch hardware, in poleline work.
Wrenches shall be of the lineman\'s type and of the following sizes, as specified (see 6.2 and 6.3):
⅝ - (See table I)
¾ - (See table I) Intended Use: The size ⅝ wrench is intended for use on ⅝-inch hardware, and the size ¾ wrench for use on ¾-inch hardware, in poleline work.
Collections
:
Show full item record
| contributor author | NAVY - YD - Naval Facilities Engineering Command | |
| date accessioned | 2017-09-04T18:36:39Z | |
| date available | 2017-09-04T18:36:39Z | |
| date copyright | 1992.04.30 | |
| date issued | 1992 | |
| identifier other | JLQWDAAAAAAAAAAA.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/218598 | |
| description abstract | This specification covers lineman\'s wrenches used in poleline work. The wrenches were formerly covered by GGG-W-644. Wrenches shall be of the lineman\'s type and of the following sizes, as specified (see 6.2 and 6.3): ⅝ - (See table I) ¾ - (See table I) Intended Use: The size ⅝ wrench is intended for use on ⅝-inch hardware, and the size ¾ wrench for use on ¾-inch hardware, in poleline work. | |
| language | English | |
| title | GGG-W-648B | num |
| title | WRENCH, LINEMAN'S | en |
| type | standard | |
| page | 8 | |
| status | Active | |
| tree | NAVY - YD - Naval Facilities Engineering Command:;1992 | |
| contenttype | fulltext |