درباره ما
ABMA 104
Rolling bearings - Thrust bearings - Boundary dimensions, general plan - Stabilized Maintenance 2010
Organization:
ABMA - American Bearing Manufacturers Association
Year: 1994
Abstract: This International Standard specifies the major boundary dimensions of single-direction and doubledirection thrust bearings with flat back faces.
In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24.
Chamfer dimensions rs and r1s apply only at the corners indicated in figures 1 and 2. No dimensions are given for other corners; however, they should not be sharp.
Maximum chamfer dimensions are given in ISO 582.
Guidelines for the extension of this International Standard for single-direction thrust bearings are given in annex A.
In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24.
Chamfer dimensions rs and r1s apply only at the corners indicated in figures 1 and 2. No dimensions are given for other corners; however, they should not be sharp.
Maximum chamfer dimensions are given in ISO 582.
Guidelines for the extension of this International Standard for single-direction thrust bearings are given in annex A.
Collections
:
Show full item record
| contributor author | ABMA - American Bearing Manufacturers Association | |
| date accessioned | 2017-09-04T18:44:12Z | |
| date available | 2017-09-04T18:44:12Z | |
| date copyright | 01/01/1994 | |
| date issued | 1994 | |
| identifier other | KDYHACAAAAAAAAAA.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/225588 | |
| description abstract | This International Standard specifies the major boundary dimensions of single-direction and doubledirection thrust bearings with flat back faces. In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24. Chamfer dimensions rs and r1s apply only at the corners indicated in figures 1 and 2. No dimensions are given for other corners; however, they should not be sharp. Maximum chamfer dimensions are given in ISO 582. Guidelines for the extension of this International Standard for single-direction thrust bearings are given in annex A. | |
| language | English | |
| title | ABMA 104 | num |
| title | Rolling bearings - Thrust bearings - Boundary dimensions, general plan - Stabilized Maintenance 2010 | en |
| type | standard | |
| page | 22 | |
| status | Active | |
| tree | ABMA - American Bearing Manufacturers Association:;1994 | |
| contenttype | fulltext |