درباره ما
Standard Specification for Coal Tar Primer Used in Roofing, Dampproofing, and Waterproofing
ASTM D43/D43M-00
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification covers coal tar primer suitable for use with coal tar pitch in roofing, dampproofing, and waterproofing below or above ground level, for application to concrete, masonry, and coal tar surfaces. Different tests shall be conducted in order to determine the following physical properties of coal tar primer: water content, consistency, specific gravity, matter insoluble in benzene, distillation, and coke residue content.
Collections
:
-
Statistics
Standard Specification for Coal Tar Primer Used in Roofing, Dampproofing, and Waterproofing
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2024-12-17T23:29:56Z | |
| date available | 2024-12-17T23:29:56Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d0043_d0043m-00r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/337956 | |
| description abstract | This specification covers coal tar primer suitable for use with coal tar pitch in roofing, dampproofing, and waterproofing below or above ground level, for application to concrete, masonry, and coal tar surfaces. Different tests shall be conducted in order to determine the following physical properties of coal tar primer: water content, consistency, specific gravity, matter insoluble in benzene, distillation, and coke residue content. | |
| language | English | |
| title | Standard Specification for Coal Tar Primer Used in Roofing, Dampproofing, and Waterproofing | en |
| title | ASTM D43/D43M-00 | num |
| type | standard | |
| page | 2 | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers coal tar primer suitable for use with coal tar pitch in roofing, dampproofing, and waterproofing below or above ground level, for application to concrete, masonry, and coal tar surfaces. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D0043_D0043M-00R24 |