درباره ما
Standard Test Method for Beam Deflection of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow
ASTM D2925-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 4.1 In the absence of deflection measurements from actual installed-above-ground piping, it is permissible to use this test method to evaluate the influence of span length on mid-span deflections at differing temperatures under full bore flow. Note 3: A flat bearing area, small contact area, and narrow bearing width may induce high localized support interaction stresses, and constraints imposed by the supports may also adversely influence deflections and performance of the pipe.
Collections
:
-
Statistics
Standard Test Method for Beam Deflection of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:58:23Z | |
| date available | 2025-09-30T17:58:23Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d2925-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340662 | |
| description abstract | 4.1 In the absence of deflection measurements from actual installed-above-ground piping, it is permissible to use this test method to evaluate the influence of span length on mid-span deflections at differing temperatures under full bore flow. Note 3: A flat bearing area, small contact area, and narrow bearing width may induce high localized support interaction stresses, and constraints imposed by the supports may also adversely influence deflections and performance of the pipe. | |
| language | English | |
| title | Standard Test Method for Beam Deflection of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow | en |
| title | ASTM D2925-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers measurement of the deflection as a function of time of a specimen of fiberglass pipe supported on a flat non-arced support as a simple beam under full bore flow of water at elevated temperatures. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are fiberglass pipes. Note 1: For the purposes of this standard, polymer does not include natural polymers. 1.2 This test method can be used to determine deflection at varying conditions by substituting other test media. 1.3 Deflections observed using this test method are representative only of piping supported as a simple beam under full bore flow which has one diameter of pipe overhanging at each support. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only. Note 2: There is no known ISO equivalent to this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D2925-24 |