درباره ما
Standard Test Method for Thermal Oxidation Stability of Aviation Turbine Fuels
ASTM D3241-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 5.1 The test results are indicative of fuel performance during gas turbine operation and can be used to assess the level of deposits that form when liquid fuel contacts a heated surface that is at a specified temperature.
Collections
:
-
Statistics
Standard Test Method for Thermal Oxidation Stability of Aviation Turbine Fuels
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:58:27Z | |
| date available | 2025-09-30T17:58:27Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d3241-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340680 | |
| description abstract | 5.1 The test results are indicative of fuel performance during gas turbine operation and can be used to assess the level of deposits that form when liquid fuel contacts a heated surface that is at a specified temperature. | |
| language | English | |
| title | Standard Test Method for Thermal Oxidation Stability of Aviation Turbine Fuels | en |
| title | ASTM D3241-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers the procedure for rating the tendencies of gas turbine fuels to deposit decomposition products within the fuel system. 1.2 The differential pressure values in mm Hg are defined only in terms of this test method. 1.3 The deposition values stated in SI units shall be regarded as the referee value. 1.4 The pressure values stated in SI units are to be regarded as standard. The psi comparison is included for operational safety with certain older instruments that cannot report pressure in SI units. 1.5 No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.1.1, 7.1, 7.3, 12.1.1, and Annex A6. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D3241-24 |