درباره ما
Standard Test Methods for Large-Scale Hydrostatic Puncture Testing of Geosynthetics
ASTM D5514/D5514M-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 4.1 Procedures B and C are performance tests intended as a design aid used to simulate the in situ behavior of geosynthetics under hydrostatic compression. These test methods may assist a design engineer in comparing the ability of several candidate geosynthetic materials to conform to a site-specific subgrade under specified use and conditions. In Procedure B, the pressure is increased until a failure is observed. In Procedure C, a given set of conditions (pressure, temperature, and test duration) are maintained constant and the performance of the system is observed at the end of the test.
Collections
:
-
Statistics
Standard Test Methods for Large-Scale Hydrostatic Puncture Testing of Geosynthetics
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:04Z | |
| date available | 2025-09-30T17:59:04Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d5514_d5514m-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340838 | |
| description abstract | 4.1 Procedures B and C are performance tests intended as a design aid used to simulate the in situ behavior of geosynthetics under hydrostatic compression. These test methods may assist a design engineer in comparing the ability of several candidate geosynthetic materials to conform to a site-specific subgrade under specified use and conditions. In Procedure B, the pressure is increased until a failure is observed. In Procedure C, a given set of conditions (pressure, temperature, and test duration) are maintained constant and the performance of the system is observed at the end of the test. | |
| language | English | |
| title | Standard Test Methods for Large-Scale Hydrostatic Puncture Testing of Geosynthetics | en |
| title | ASTM D5514/D5514M-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 These test methods evaluate the stress/time properties of geosynthetics by using hydrostatic pressure to compress the geosynthetic over a subgrade. 1.2 These test methods allow the user to determine the relative failure mode or points of failure for geosynthetics, or both. 1.3 Procedures B and C incorporate site-specific soil or other material selected by the user as the test base of the testing apparatus. Procedures B and C are methods for geosynthetic design for a specific site. Note 1: Earlier versions of this test method incorporated a ‘Procedure A’ involving manufactured test pyramids or cones as the base of the testing apparatus. This procedure was withdrawn, but the designations B and C were retained to avoid confusion on historical specifications and technical data sheets. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement, see Section 6. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D5514_D5514M-24 |