درباره ما
Standard Test Method for Evaluation of Corrosiveness of Diesel Engine Oil at 121 °C
ASTM D5968-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 5.1 This test method is intended to simulate the corrosion process of non-ferrous metals in diesel lubricants. The corrosion process under investigation is that believed to be induced primarily by inappropriate lubricant chemistry rather than lubricant degradation or contamination. This test method has been found to correlate with an extensive fleet database containing corrosion-induced cam and bearing failures.
Collections
:
-
Statistics
Standard Test Method for Evaluation of Corrosiveness of Diesel Engine Oil at 121 °C
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:11Z | |
| date available | 2025-09-30T17:59:11Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d5968-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340869 | |
| description abstract | 5.1 This test method is intended to simulate the corrosion process of non-ferrous metals in diesel lubricants. The corrosion process under investigation is that believed to be induced primarily by inappropriate lubricant chemistry rather than lubricant degradation or contamination. This test method has been found to correlate with an extensive fleet database containing corrosion-induced cam and bearing failures. | |
| language | English | |
| title | Standard Test Method for Evaluation of Corrosiveness of Diesel Engine Oil at 121 °C | en |
| title | ASTM D5968-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method is used to test diesel engine lubricants to determine their tendency to corrode various metals, specifically alloys of lead and copper commonly used in cam followers and bearings. Correlation with field experience has been established.2 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 6.3.1, 7.5, 7.6, 7.7, 7.8, 7.9, 8.1.1, 8.1.2, and 8.1.5. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D5968-24 |