درباره ما
Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density
ASTM D6814-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 5.1 It is important for rubber compounders to know the extent of devulcanization a rubber might have undergone during recycling. It allows the compounder to determine if more curing agents are needed during mixing of devulcanized rubber when used either as partial replacement or stand alone.
Collections
:
-
Statistics
Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:31Z | |
| date available | 2025-09-30T17:59:31Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d6814-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340951 | |
| description abstract | 5.1 It is important for rubber compounders to know the extent of devulcanization a rubber might have undergone during recycling. It allows the compounder to determine if more curing agents are needed during mixing of devulcanized rubber when used either as partial replacement or stand alone. | |
| language | English | |
| title | Standard Test Method for Determination of Percent Devulcanization of Crumb Rubber Based on Crosslink Density | en |
| title | ASTM D6814-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers the procedure for determining percent devulcanization from crosslink density measurements of devulcanized rubber and control crumb rubber in the laboratory. Percent devulcanization is a quantitative determination. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D6814-24 |