درباره ما
Standard Specification for Low Toluene Low Dioxane (LTLD) Benzene
ASTM D7185-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification covers the requirements for a grade of benzene known as low toluene low dioxane (LTLD) benzene. Sampled materials shall meet specified values of the following physical and chemical properties: purity; toluene content; sulfur content; thiophene content; nonaromatic hydrocarbons content; nitrogen content; acid wash color; color in Pt-Co scale; 1,4 dioxane content; anhydrous basis solidification point; water content; and total chlorides.
Collections
:
-
Statistics
Standard Specification for Low Toluene Low Dioxane (LTLD) Benzene
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:39Z | |
| date available | 2025-09-30T17:59:39Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d7185-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/340982 | |
| description abstract | This specification covers the requirements for a grade of benzene known as low toluene low dioxane (LTLD) benzene. Sampled materials shall meet specified values of the following physical and chemical properties: purity; toluene content; sulfur content; thiophene content; nonaromatic hydrocarbons content; nitrogen content; acid wash color; color in Pt-Co scale; 1,4 dioxane content; anhydrous basis solidification point; water content; and total chlorides. | |
| language | English | |
| title | Standard Specification for Low Toluene Low Dioxane (LTLD) Benzene | en |
| title | ASTM D7185-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers a grade of benzene known as Low Toluene Low Dioxane (LTLD) Benzene. 1.2 The following applies to all specified limits in this standard: for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. 1.3 Consult current OSHA regulations, supplier’s Safety Data Sheets, and local regulations for all materials used in this specification. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D7185-24 |