درباره ما
Standard Specification for Disproportionation (TDP) Toluene
ASTM D7951-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification establishes requirements for disproportionation (TDP) toluene. For purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit. This specification covers properties and sampling of the material.
Collections
:
-
Statistics
Standard Specification for Disproportionation (TDP) Toluene
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T17:59:52Z | |
| date available | 2025-09-30T17:59:52Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d7951-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341046 | |
| description abstract | This specification establishes requirements for disproportionation (TDP) toluene. For purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit. This specification covers properties and sampling of the material. | |
| language | English | |
| title | Standard Specification for Disproportionation (TDP) Toluene | en |
| title | ASTM D7951-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers Disproportionation (TDP) toluene. 1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 Consult current OSHA regulations, supplier’s Safety Data Sheets, and local regulations for all materials used in this specification. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D7951-24 |