درباره ما
Standard Practice for Rapid Indentation Hardness Testing of Metallic Materials
ASTM E103-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 4.1 This practice is used when it is desired to make Brinell type hardness tests very rapidly on a high volume of specimens, as in the inspection of the output of a heat-treating furnace. 4.2 This practice requires the measurement of indentation depth and eliminates the need to measure the diameter of the indentation optically as required in a Brinell hardness test. 4.3 This practice is not a standard Brinell hardness test method and does not meet the requirements of Test Method E10. 4.4 Since the test forces and method of display of the depth measurement differ between manufacturers of rapid indentation hardness testing equipment, the test results from equipment from different manufacturers are not comparable.
Collections
:
-
Statistics
Standard Practice for Rapid Indentation Hardness Testing of Metallic Materials
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:00:19Z | |
| date available | 2025-09-30T18:00:19Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | e0103-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341153 | |
| description abstract | 4.1 This practice is used when it is desired to make Brinell type hardness tests very rapidly on a high volume of specimens, as in the inspection of the output of a heat-treating furnace. 4.2 This practice requires the measurement of indentation depth and eliminates the need to measure the diameter of the indentation optically as required in a Brinell hardness test. 4.3 This practice is not a standard Brinell hardness test method and does not meet the requirements of Test Method E10. 4.4 Since the test forces and method of display of the depth measurement differ between manufacturers of rapid indentation hardness testing equipment, the test results from equipment from different manufacturers are not comparable. | |
| language | English | |
| title | Standard Practice for Rapid Indentation Hardness Testing of Metallic Materials | en |
| title | ASTM E103-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This practice covers a procedure for rapid indentation hardness testing of metallic materials. 1.2 This practice includes additional requirements in Annex A1 for the direct, indirect, and daily verification of rapid indentation hardness testing machines. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/E0103-24 |