درباره ما
Standard Test Method for Strength Properties of Double Lap Shear Adhesive Joints by Tension Loading
ASTM D3528-96
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 4.1 This test method is designed to produce shear property data for the process control and specification of adhesives. This test method may also be useful for research and development of adhesives. 4.2 Lap shear properties vary with specimen configuration preparation, speed, and environment of testing. Consequently, where precise comparative results are desired, these factors must be carefully controlled and reported.
Collections
:
-
Statistics
Standard Test Method for Strength Properties of Double Lap Shear Adhesive Joints by Tension Loading
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:00:52Z | |
| date available | 2025-09-30T18:00:52Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d3528-96r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341296 | |
| description abstract | 4.1 This test method is designed to produce shear property data for the process control and specification of adhesives. This test method may also be useful for research and development of adhesives. 4.2 Lap shear properties vary with specimen configuration preparation, speed, and environment of testing. Consequently, where precise comparative results are desired, these factors must be carefully controlled and reported. | |
| language | English | |
| title | Standard Test Method for Strength Properties of Double Lap Shear Adhesive Joints by Tension Loading | en |
| title | ASTM D3528-96 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers the determination of the tensile shear strengths of adhesives for bonding metals when tested in an essentially peel-free standard specimen that develops adhesive stress distribution representative of that developed in a typical low-peel production-type structural joint. The reproducibility of the strengths achieved are directly related to conformance with specified conditions of preparation and testing. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D3528-96R24 |