درباره ما
Standard Practice for Rubber—Directions for Achieving Subnormal Test Temperatures
ASTM D3847-01
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 3.1 Low temperatures are often needed for conditioning of rubber prior to testing, as well as during the test. Conditioning is required to attain a specific temperature that is uniform throughout the specimen or for producing time-dependent effects. Specimens may be conditioned and tested in the same or different chambers. 3.2 This practice is intended to apply particularly, but not exclusively, to the following ASTM Standards: Test Methods D746, D945, D1053, D1229, D1329, D1415, D2136, D2137, D2240, D2632, Practice D832, and Specification E197.
Collections
:
-
Statistics
Standard Practice for Rubber—Directions for Achieving Subnormal Test Temperatures
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:01:37Z | |
| date available | 2025-09-30T18:01:37Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | d3847-01r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341463 | |
| description abstract | 3.1 Low temperatures are often needed for conditioning of rubber prior to testing, as well as during the test. Conditioning is required to attain a specific temperature that is uniform throughout the specimen or for producing time-dependent effects. Specimens may be conditioned and tested in the same or different chambers. 3.2 This practice is intended to apply particularly, but not exclusively, to the following ASTM Standards: Test Methods D746, D945, D1053, D1229, D1329, D1415, D2136, D2137, D2240, D2632, Practice D832, and Specification E197. | |
| language | English | |
| title | Standard Practice for Rubber—Directions for Achieving Subnormal Test Temperatures | en |
| title | ASTM D3847-01 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This practice covers the general requirements for achieving and maintaining temperatures below 21°C for thermal conditioning and physical testing of rubber. 1.2 This practice describes the acceptable types and construction of low-temperature cabinets for conditioning and testing of rubber, the composition and circulation of heat-transfer media, and the required uniformity and precision of temperature control. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/D3847-01R24 |