درباره ما
Standard Specification for Stainless Steel Nuts
ASTM F594-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 15.1 For the purposes of determining compliance with the specified limits for properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.
Collections
:
-
Statistics
Standard Specification for Stainless Steel Nuts
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:01:47Z | |
| date available | 2025-09-30T18:01:47Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f0594-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341506 | |
| description abstract | 15.1 For the purposes of determining compliance with the specified limits for properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29. | |
| language | English | |
| title | Standard Specification for Stainless Steel Nuts | en |
| title | ASTM F594-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance. 1.2 Seven groups of stainless steel alloys are covered, including fourteen austenitic, two ferritic, four martensitic, and one precipitation hardening. Group AlloysA ConditionB 1 304, 305, 304L 384, 18–9LW, 302HQ, 304J3C (CW) cold workedD 2 316, 316L (CW) cold workedD 3 321, 347 (CW) cold workedD 4 430E (CW) cold workedD 5 410F (H) hardened and tempered 6 431 (H) hardened and tempered 7 630 (AH) aged hardened 1.3 Supplementary requirements of an optional nature are provided, applicable only when agreed upon by the manufacturer and the purchaser at the time of the inquiry and order. 1.4 Suitable bolts, hex cap screws, and studs for use with nuts included in this specification are covered by Specification F593. Unless otherwise specified, all bolts, hex cap screws, and studs used with these nuts shall conform to the requirements of Specification F593 and shall be of the same alloy group. 1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F0594-24 |