درباره ما
Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws
ASTM F880-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification covers the requirements for austenitic grade stainless steel socket set screws (SSS), sizes M1.6 through M24, having property classes A1-50 and A1-70. The analysis of the screw material shall conform to the chemical composition specified. Socket set screw shall be subjected to torque test, Vickers hardness test, and corrosion resistance test to meet the requirements prescribed.
Collections
:
-
Statistics
Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:01:51Z | |
| date available | 2025-09-30T18:01:51Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f0880-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341526 | |
| description abstract | This specification covers the requirements for austenitic grade stainless steel socket set screws (SSS), sizes M1.6 through M24, having property classes A1-50 and A1-70. The analysis of the screw material shall conform to the chemical composition specified. Socket set screw shall be subjected to torque test, Vickers hardness test, and corrosion resistance test to meet the requirements prescribed. | |
| language | English | |
| title | Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws | en |
| title | ASTM F880-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 1.000 in. square head set screws (SHSS) sizes 0.190 through 1.500 in., and slotted headless set screws (HSS) 0.060 through 0.750 in., in two conditions, AF and CW. 1.2 Units—The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard. Note 1: A complete metric companion to Specification F880 has been developed—F880M; therefore, no metric equivalents are shown in this specification. 1.3 The following hazards caveat pertains only to Test Method Section, Section 12 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F0880-24 |