درباره ما
Standard Specification for Butt Heat Fusion Polyamide(PA) Plastic Fitting for Polyamide(PA) Plastic Pipe and Tubing
ASTM F1733-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification covers polyamide (PA) butt fusion fittings for use with polyamide pipe (IPS and ISO) and tubing (CTS). This specification covers butt fusion fittings intended for use with polyamide pipe and tubing. Fittings covered by this specification are normally molded. Fittings may be machined from extruded or molded stock. Conditioning, dimensions and tolerances, short-term rupture strength, sustained pressure test, and minimum hydrostatic burst pressure test shall be performed to conform with the requirements specified.
Collections
:
-
Statistics
Standard Specification for Butt Heat Fusion Polyamide(PA) Plastic Fitting for Polyamide(PA) Plastic Pipe and Tubing
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:02:00Z | |
| date available | 2025-09-30T18:02:00Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f1733-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341566 | |
| description abstract | This specification covers polyamide (PA) butt fusion fittings for use with polyamide pipe (IPS and ISO) and tubing (CTS). This specification covers butt fusion fittings intended for use with polyamide pipe and tubing. Fittings covered by this specification are normally molded. Fittings may be machined from extruded or molded stock. Conditioning, dimensions and tolerances, short-term rupture strength, sustained pressure test, and minimum hydrostatic burst pressure test shall be performed to conform with the requirements specified. | |
| language | English | |
| title | Standard Specification for Butt Heat Fusion Polyamide(PA) Plastic Fitting for Polyamide(PA) Plastic Pipe and Tubing | en |
| title | ASTM F1733-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers polyamide (PA) butt fusion fittings for use with polyamide pipe (IPS and Metric) and tubing (CTS). Included are requirements for materials, workmanship, dimensions, marking, sustained pressure, and burst pressure. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F1733-24 |