درباره ما
Standard Test Method for Evaluation of MR Image Artifacts from Passive Implants
ASTM F2119-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 5.1 This test method provides a quantified measure of the image artifact produced under a standard set of scanning conditions. 5.2 This test method applies only to passive implants that have been established to be MR-Safe or MR-Conditional.
Collections
:
-
Statistics
Standard Test Method for Evaluation of MR Image Artifacts from Passive Implants
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:02:07Z | |
| date available | 2025-09-30T18:02:07Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f2119-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341595 | |
| description abstract | 5.1 This test method provides a quantified measure of the image artifact produced under a standard set of scanning conditions. 5.2 This test method applies only to passive implants that have been established to be MR-Safe or MR-Conditional. | |
| language | English | |
| title | Standard Test Method for Evaluation of MR Image Artifacts from Passive Implants | en |
| title | ASTM F2119-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method characterizes the distortion and signal loss artifacts produced in a magnetic resonance (MR) image by a passive implant (implant that functions without the supply of electrical or external power). Anything not established to be MR-Safe or MR-Conditional is excluded. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F2119-24 |