درباره ما
Standard Specification for Impact Attenuation of Wall Padding Used in Indoor Competitive and Recreational Sports Venues
ASTM F2440-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 5.1 The padding shall be constructed to yield the values listed in Table 1 throughout the impact area under the conditions of the manufacturer's warranty. (A) As specified by manufacturer 5.2 Special requirements for the padding shall be subject to purchase agreements. Special requirements shall never reduce any of the basic requirements listed in this standard. 5.3 Good manufacturing practices shall be used in the construction and inspection of the padding.
Collections
:
-
Statistics
Standard Specification for Impact Attenuation of Wall Padding Used in Indoor Competitive and Recreational Sports Venues
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:02:16Z | |
| date available | 2025-09-30T18:02:16Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f2440-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/341632 | |
| description abstract | 5.1 The padding shall be constructed to yield the values listed in Table 1 throughout the impact area under the conditions of the manufacturer's warranty. (A) As specified by manufacturer 5.2 Special requirements for the padding shall be subject to purchase agreements. Special requirements shall never reduce any of the basic requirements listed in this standard. 5.3 Good manufacturing practices shall be used in the construction and inspection of the padding. | |
| language | English | |
| title | Standard Specification for Impact Attenuation of Wall Padding Used in Indoor Competitive and Recreational Sports Venues | en |
| title | ASTM F2440-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers wall padding and padding for other indoor structures. All padding constructions are included. The intended use of this specification is for the qualification of construction designs and comparison of products. Note 1: This specification was developed due to the numerous designs in existence and the need to provide a method to determine if a wall pad meets a minimum level of protection. Note 2: There is no equivalent ISO standard. 1.2 The values as stated in SI units are to be regarded as the standard. The values in parentheses are given for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 7.1 for specific hazards statement. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F2440-24 |