درباره ما
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
ASTM F725-03
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 5.1 This practice is used for drafting impact test specification requirements, and it presupposes no special familiarity with statistical methods. It provides for specification values that will pass acceptable lots with a high degree of certainty. The impact test requirement is intended to discriminate between acceptable materials and manufacturing methods and those which are not; it is not a simulated service test.
Collections
:
-
Statistics
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:03:58Z | |
| date available | 2025-09-30T18:03:58Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f0725-03r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342026 | |
| description abstract | 5.1 This practice is used for drafting impact test specification requirements, and it presupposes no special familiarity with statistical methods. It provides for specification values that will pass acceptable lots with a high degree of certainty. The impact test requirement is intended to discriminate between acceptable materials and manufacturing methods and those which are not; it is not a simulated service test. | |
| language | English | |
| title | Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards | en |
| title | ASTM F725-03 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444. 1.2 This practice is applicable to thermoplastic pipe and fittings. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F0725-03R24 |