درباره ما
Standard Specification for Residential Central-Vacuum Tube and Fittings
ASTM F2158-08
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification establishes requirements and test methods for materials, dimensions and tolerances, flattening resistance and impact resistance of plastic tubing and fittings for use in central-vacuum systems for residential buildings. The tube and fittings shall be homogeneous throughout and free of visible cracks, holes, foreign inclusions, or other defects. The tube flattening, tube impact strength, tube dimensions, tube length, and fitting dimensions shall be tested to meet the requirements prescribed.
Collections
:
-
Statistics
Standard Specification for Residential Central-Vacuum Tube and Fittings
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:04:27Z | |
| date available | 2025-09-30T18:04:27Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | f2158-08r24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342115 | |
| description abstract | This specification establishes requirements and test methods for materials, dimensions and tolerances, flattening resistance and impact resistance of plastic tubing and fittings for use in central-vacuum systems for residential buildings. The tube and fittings shall be homogeneous throughout and free of visible cracks, holes, foreign inclusions, or other defects. The tube flattening, tube impact strength, tube dimensions, tube length, and fitting dimensions shall be tested to meet the requirements prescribed. | |
| language | English | |
| title | Standard Specification for Residential Central-Vacuum Tube and Fittings | en |
| title | ASTM F2158-08 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers the establishment of requirements and test methods for materials, dimensions and tolerances, flattening resistance and impact resistance of plastic tubing for use in central-vacuum systems for residential buildings. 1.2 All notes and footnotes shall be considered as nonmandatory requirements of the specification. 1.3 This specification does not apply to: inlet valve mounting plates of fittings directly connected to these plates, reducer fittings, mufflers exhaust vents, or flex tubing attached at the power unit location. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/F2158-08R24 |