درباره ما
Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished
ASTM A108-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification covers cold-finished carbon and alloy steel bars for heat treatment, machining into components, or for as-finished condition as shafting or in constructional applications. The steel materials shall be cold drawn, turned, ground, polished, hot wrought, cold rolled, and heat treated. The steel specimens shall undergo chemical analysis.
Collections
:
-
Statistics
Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:04:54Z | |
| date available | 2025-09-30T18:04:54Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | a0108-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342186 | |
| description abstract | This specification covers cold-finished carbon and alloy steel bars for heat treatment, machining into components, or for as-finished condition as shafting or in constructional applications. The steel materials shall be cold drawn, turned, ground, polished, hot wrought, cold rolled, and heat treated. The steel specimens shall undergo chemical analysis. | |
| language | English | |
| title | Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished | en |
| title | ASTM A108-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers cold-finished carbon and alloy steel bars produced in straight length and coil. Cold-finished bars are suitable for heat treatment, for machining into components, or for use in the as-finished condition as shafting, or in constructional applications, or for other similar purposes (Note 1). Grades of steel are identified by grade numbers or by chemical composition. Note 1: A guide for the selection of steel bars is contained in Practice A400. 1.2 Some end uses may require one or more of the available designations shown under Supplementary Requirements. Supplementary requirements shall apply only when specified individually by the purchaser. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/A0108-24 |