درباره ما
Standard Practice for Hot Isostatic Pressing of Steel, Stainless Steel, and Related Alloy Castings
ASTM A1080/A1080M-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This practice covers general requirements for Hot Isostatic Pressing (HIP) of steel, stainless steel, and related alloy castings. HIP is a solid state process which applies heat and pressure simultaneously to objects in an autoclave via an inert gas in such a way as to eliminate internal voids and obtain desired properties. Inert gas is a non-oxidizing gas used for pressurizing a HIP vessel. This practice deals with quality requirements, autoclave type/qualification, temperature uniformity, temperature measurement and control, pressure measurement and control, and gas measurement.
Collections
:
-
Statistics
Standard Practice for Hot Isostatic Pressing of Steel, Stainless Steel, and Related Alloy Castings
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:06:01Z | |
| date available | 2025-09-30T18:06:01Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | a1080_a1080m-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342326 | |
| description abstract | This practice covers general requirements for Hot Isostatic Pressing (HIP) of steel, stainless steel, and related alloy castings. HIP is a solid state process which applies heat and pressure simultaneously to objects in an autoclave via an inert gas in such a way as to eliminate internal voids and obtain desired properties. Inert gas is a non-oxidizing gas used for pressurizing a HIP vessel. This practice deals with quality requirements, autoclave type/qualification, temperature uniformity, temperature measurement and control, pressure measurement and control, and gas measurement. | |
| language | English | |
| title | Standard Practice for Hot Isostatic Pressing of Steel, Stainless Steel, and Related Alloy Castings | en |
| title | ASTM A1080/A1080M-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This practice covers general requirements for hot isostatic pressing (HIP) of steel, stainless steel, and related alloy castings. 1.2 This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable M-specification designation (SI units), the inch-pound units shall apply. 1.3 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/A1080_A1080M-24 |