درباره ما
Standard Specification for Commercial Bronze Strip for Bullet Jackets
ASTM B130-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 17.1 For purposes of determining compliance with the specified property limits for the properties listed in the following table, an observed value of a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29: Property Rounded Unit for Observed or Calculated Value Chemical composition Hardness nearest unit in the last right-hand significant digit used in expressing the limiting value. Tensile strength nearest ksi (5 MPa) Grain size: Up to 0.055 mm, incl nearest multiple of 0.005 mm Over 0.055 mm to 0.160 mm, incl nearest 0.01 mm Elongation: 5 % and over nearest 1 %
Collections
:
-
Statistics
Standard Specification for Commercial Bronze Strip for Bullet Jackets
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:06:05Z | |
| date available | 2025-09-30T18:06:05Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | b0130-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342335 | |
| description abstract | 17.1 For purposes of determining compliance with the specified property limits for the properties listed in the following table, an observed value of a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29: Property Rounded Unit for Observed or Calculated Value Chemical composition Hardness nearest unit in the last right-hand significant digit used in expressing the limiting value. Tensile strength nearest ksi (5 MPa) Grain size: Up to 0.055 mm, incl nearest multiple of 0.005 mm Over 0.055 mm to 0.160 mm, incl nearest 0.01 mm Elongation: 5 % and over nearest 1 % | |
| language | English | |
| title | Standard Specification for Commercial Bronze Strip for Bullet Jackets | en |
| title | ASTM B130-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers the requirements for commercial bronze strip for manufacture of bullet jacket cups and ammunition components from Copper Alloy UNS No. C22000.2 1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The following safety hazard caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0130-24 |