درباره ما
Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
ASTM B680-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: 3.1 This test method describes a destructive test procedure for measuring the degree of seal of the porosity in anodic oxide coatings. Low coating mass loss is an indication of good seal quality and of the ability of the coating to resist staining and “blooming” in many types of service. 3.2 This test method is suitable for quality control purposes within manufacturing operations and for determining whether anodized parts meet seal quality requirements in applicable specifications.
Collections
:
-
Statistics
Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:06:19Z | |
| date available | 2025-09-30T18:06:19Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | b0680-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342375 | |
| description abstract | 3.1 This test method describes a destructive test procedure for measuring the degree of seal of the porosity in anodic oxide coatings. Low coating mass loss is an indication of good seal quality and of the ability of the coating to resist staining and “blooming” in many types of service. 3.2 This test method is suitable for quality control purposes within manufacturing operations and for determining whether anodized parts meet seal quality requirements in applicable specifications. | |
| language | English | |
| title | Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution | en |
| title | ASTM B680-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This test method covers a test for the quality of seal of porous anodic coatings on aluminum and its alloys. It is based upon the loss in mass of the coating after immersion in a warm phosphoric-chromic acid solution. 1.2 This test method is applicable to anodic coatings intended for exposure to the weather, or for protective purposes in corrosive media, and where resistance to staining is important. 1.3 This test method is not applicable to: 1.3.1 Hard coatings, which normally are not sealed. 1.3.2 Anodic coatings that have been sealed only in dichromate solutions. 1.3.3 Anodic coatings that have undergone a treatment to render them hydrophobic. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0680-24 |