درباره ما
Standard Specification for Gypsum Veneer Plaster
ASTM C587-24
Organization:
ASTM - ASTM International
Year: 2024
Abstract: This specification covers calcined gypsum mixed at the mill with other ingredients to control working quality and setting time; specifically designed as a veneer plaster to be applied over gypsum base for veneer plasters, masonry or concrete surfaces, providing a surface ready for decoration. In addition, this specification covers test methods for determining the physical properties of gypsum veneer plasters. Veneer plasters shall be tested and shall conform to specified values of joint strength, bond strength, impact strength, and flexure.
Collections
:
-
Statistics
Standard Specification for Gypsum Veneer Plaster
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T18:07:01Z | |
| date available | 2025-09-30T18:07:01Z | |
| date copyright | 2024 | |
| date issued | 2024 | |
| identifier other | c0587-24.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342460 | |
| description abstract | This specification covers calcined gypsum mixed at the mill with other ingredients to control working quality and setting time; specifically designed as a veneer plaster to be applied over gypsum base for veneer plasters, masonry or concrete surfaces, providing a surface ready for decoration. In addition, this specification covers test methods for determining the physical properties of gypsum veneer plasters. Veneer plasters shall be tested and shall conform to specified values of joint strength, bond strength, impact strength, and flexure. | |
| language | English | |
| title | Standard Specification for Gypsum Veneer Plaster | en |
| title | ASTM C587-24 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2024 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers calcined gypsum mixed at the mill with other ingredients to control working quality and setting time; specifically designed as a veneer plaster to be applied over gypsum base for veneer plasters, masonry or concrete surfaces to a maximum thickness of 1/4 in. (6.4 mm) providing a surface ready for decoration. Note 1: Specification C843 contains application procedures for gypsum veneer plaster. 1.2 This specification covers test methods for determining the physical properties of gypsum veneer plasters and sets forth minimum requirements that must be met. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered as requirements of the standard. 1.5 The following safety hazards caveat applies only to the Test Methods portion, Section 5 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/C0587-24 |