درباره ما
Standard Specification for Niobium-Hafnium Alloy Ingots
ASTM B652/B652M-25
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 10.1 The following applies to all specified limits in this standard for purposes of determining conformance with this specification: The observed value or a calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
Collections
:
-
Statistics
Standard Specification for Niobium-Hafnium Alloy Ingots
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:19:51Z | |
| date available | 2025-09-30T19:19:51Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | b0652_b0652m-25.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342870 | |
| description abstract | 10.1 The following applies to all specified limits in this standard for purposes of determining conformance with this specification: The observed value or a calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. | |
| language | English | |
| title | Standard Specification for Niobium-Hafnium Alloy Ingots | en |
| title | ASTM B652/B652M-25 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers hafnium alloyed niobium ingots prepared by vacuum- or plasma- arc melting or electron-beam furnace melting, or a combination of these methods, to produce consolidated metal for processing to various mill shapes. 1.2 The material covered by this specification is Grade R04295, niobium-base alloy containing approximately 10 % hafnium and 1 % titanium. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0652_B0652M-25 |