درباره ما
Standard Specification for Niobium-Hafnium Alloy Bar and Wire
ASTM B655/B655M-25
Organization:
ASTM - ASTM International
Year: 2025
Abstract: 12.1 The following applies to all specified limits in this standard for purposes of determining conformance with this specification. The observed value or a calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
Collections
:
-
Statistics
Standard Specification for Niobium-Hafnium Alloy Bar and Wire
Show full item record
| contributor author | ASTM - ASTM International | |
| date accessioned | 2025-09-30T19:20:08Z | |
| date available | 2025-09-30T19:20:08Z | |
| date copyright | 2025 | |
| date issued | 2025 | |
| identifier other | b0655_b0655m-25.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/342903 | |
| description abstract | 12.1 The following applies to all specified limits in this standard for purposes of determining conformance with this specification. The observed value or a calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. | |
| language | English | |
| title | Standard Specification for Niobium-Hafnium Alloy Bar and Wire | en |
| title | ASTM B655/B655M-25 | num |
| type | standard | |
| status | Active | |
| tree | ASTM - ASTM International:;2025 | |
| contenttype | fulltext | |
| scope | 1.1 This specification covers hafnium alloyed niobium bar and wire. 1.2 The material covered by this specification is R04295, niobium-base alloy containing approximately 10 % hafnium and 1 % titanium. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 The following safety hazards caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. | |
| identifier DOI | 10.1520/B0655_B0655M-25 |