MIL-T-18232B

Abstract

This specification embodies the general requirements of the Naval Air Systems Command Headquarters (NAVAIR) for the design and construction of aerial powered targets, other than converted aircraft targets. The following shall apply to the specific target concerned: <br>Navy model designation <br>Designer's name <br>Designer's Model designation <br>Number and kind of engine(s) <br>The mission of the target shall be as specified in the type or detail specification. <br>Targets designed and constructed under this specification are classified as follows: <br>(a) Experimental. <br>(b) Developmental. <br>(c) Prototype. <br>(d) Production. <b><u>Intended Use:</u></b> This general specification shall be used as the standard form for the preparation of detail and type specifications. Detail and type specifications shall be prepared as follows: - Detail specifications shall conform to the following: All paragraph numbers and topic headings shall be listed in the order shown in this general specification except that, where a paragraph and all of its subparagraphs are either applicable, not applicable or not required in their entirety, the paragraph and all subparagraph numbers may be listed under one topic heading and appropriately labeled, e.g. <pre> 3.13.1 HYDRAULIC SYSTEM. - Not applicable. thru 3.13.1.4</pre> Paragraphs of this general specification which are completely applicable to the particular design shall be labeled "applicable"; paragraphs which completely supersede the requirements of this general specification shall be completely rewritten; paragraphs which contain deviations or supplementary requirements shall be labeled "applicable" and the deviation or supplementary requirement incorporated therein; paragraphs of the general specification containing requirements that are not applicable to the particular design shall be labeled "not applicable"; and paragraphs which waive a requirement of the general specification normally applicable to the particular design shall be labeled "not required". Add paragraphs as required. The instructions applicable to the preparation of detail specifications apply to the preparation of type specifications except that only those paragraphs of the general specification necessary to define the essential characteristics of the particular design need be listed. <br>