Show simple item record

Standard Practice for Sampling and Fabrication of 50-mm (2-in.) Cube Specimens Using Grout (Non-Shrink) or Morta

contributor authorAASHTO - American Association of State Highway and Transportation Officials
date accessioned2017-09-04T16:15:10Z
date available2017-09-04T16:15:10Z
date copyright2015.01.01
date issued2015
identifier otherSWCXKFAAAAAAAAAA.pdf
identifier urihttps://yse.yabesh.ir/std/handle/yse/78350
description abstractThis practice covers field sampling and fabrication and initial curing of 50-mm (2-in.) cube specimens of nonshrink grout or mortar materials, or both.
The values stated in either inch-pound or SI units shall be regarded separately as standard. The inch-pound units are shown in parentheses. The values stated might not be exact equivalents; therefore, each system must be used independently of the other.
Note 1—"Unit weight" was the previous terminology used to describe the property determined by this practice, which is mass per unit volume.
The text of this practice references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of this practice.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.
languageEnglish
titleAASHTO R 64num
titleStandard Practice for Sampling and Fabrication of 50-mm (2-in.) Cube Specimens Using Grout (Non-Shrink) or Mortaen
typestandard
page5
statusActive
treeAASHTO - American Association of State Highway and Transportation Officials:;2015
contenttypefulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record