Show simple item record

ENGINEERING DRAWING PRACTICES VOLUME 1 OF II AEROSPACE AND GROUND SUPPORT EQUIPMENT

contributor authorKSC - NASA - KSC - Kennedy Space Center
date accessioned2017-09-04T16:27:28Z
date available2017-09-04T16:27:28Z
date copyright03/24/2003
date issued2003
identifier otherBODQFBAAAAAAAAAA.pdf
identifier urihttps://yse.yabesh.ir/std/handle/yse/90623
description abstractThis manual establishes the requirements, procedures, and practices for the preparation, release, revision, modification, maintenance, and control of engineering drawings prepared for or by the John F. Kennedy Space Center (KSC), NASA. Volume I of this manual applies to those drawings used to fabricate, construct, install, test, operate, maintain, and otherwise utilize aerospace and ground support equipment (GSE) at KSC. Volume II applies to drawings used to construct, test, operate, maintain, and otherwise utilize facilities at KSC. These requirements do not apply to the preparation of illustrations, artwork, or figures in technical publications. KSC engineering design practices shall be in accordance with KSC-DE-512-SM and are not included in this document.
To establish uniform engineering practices and methods for the preparation and revision of aerospace and ground support equipment engineering drawings used at KSC, volume I provides:
a. Drafting practices including mechanical and electrical conventions
b. Drawing formats
c. Types of engineering drawings
d. Procedures for the creation of titles for drawings
e. Methods for revision and change of drawings
f. Procedures for numbering and identification of drawings and part identification
languageEnglish
titleKSC-GP-435 VOL I REV F CHANGE 2num
titleENGINEERING DRAWING PRACTICES VOLUME 1 OF II AEROSPACE AND GROUND SUPPORT EQUIPMENTen
typestandard
page254
statusActive
treeKSC - NASA - KSC - Kennedy Space Center:;2003
contenttypefulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record