MIL-DTL-11484/167B

Abstract

This specification is approved for use by all Departments and Agencies of the Department of Defense. <br>The requirements for acquiring the product described herein shall consist of this specification sheet and the issue of MIL-DTL-11484 listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation. <a><img alt="FIGURE" /></a> </span><pre>MATERIAL: DASH NO. -1: Gilding Metal -1: 5 Years (Bronze) -2: Nickel Silver or Red Brass -2: 10 Years (Silver) -3: Red Brass -3: 15 Years (Gold) FINISH: -1: Oxidized, Relieved, Matte Finish -2: Nickel Plated (Red Brass only), Silver Plated, Oxidized, Relieved, Matte Finish and shall match TIOH Metal Finish Chip Number 14. -3: Gold Plated, Matte Finish, Polished Highlights and shall match TIOH Metal Finish Chip Number 8.</pre> <br> <pre>DIMENSIONS: DIAMETER: &#189; inch (1.27 cm) (REF) DIAMETER (At Widest Point): &#8541; inch (1.59 cm) (REF) THICKNESS (At thickest Point): 0.065 inch &#177; 0.005 inch (0.165 cm &#177; 0.012 cm)</pre> <br> <br>NOTES: <br>1. The term (REF) refers to the measurements taken from the Government furnished hub or die. <br>2. Attaching device shall be prong with pick and flat ball type clutch or a pin and catch as specified in the procurement document. When a prong type device is required, the prong shall be centered on the reverse side and fused or soldered to the lapel button. When a pin type attaching device is required, the device shall be located 1/16 inch (0.16 cm) above the horizontal center line on the reverse side. <br>3. Finished lapel buttons shall be lacquered. <br>CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. <br>